answersLogoWhite

0

I think they are also refering to a fuel pressure regulator but not sure.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the PCV valve on the 1995 Jeep Grand Cherokee Laredo V6 engine?

The PCV valve on the 1995 Jeep Grand Cherokee Laredo V6 engine is on the oil filler tube. It is on the top of the engine.


Why does the Jeep Grand Cherokee Laredo not stay idled?

Idle air control valve found on Tue backside of throttle body.


Why would dealership remove the abs valve fuse on a jeep grand Cherokee Laredo prior to sale?

to turn the abs light off


Where is the transmission solenoid on a 96 grand Cherokee Laredo?

On a 1996 Jeep Grand Cherokee Laredo, the transmission solenoid is typically located inside the transmission valve body. To access it, you generally need to remove the transmission pan and the valve body. The solenoid is usually mounted on the valve body and may be connected to the wiring harness. Always refer to a repair manual for specific instructions and safety precautions.


Where is the input speed sensor on a 2008 Jeep Cherokee Laredo?

in the valve body which is inside the transmission.


97 Jeep Grand Cherokee egr valve location?

The 2002 Grand Vitara EGR valve is located on top of the engine. The EGR valve will be between the engine and the battery.


What is the valve on the valve cover of a 1999 Jeep Grand Cherokee?

It is the Positive Crankcase Ventilation (PCV) valve.


Where is the transmission control solenoid located on a 2003 Jeep Cherokee Laredo?

The transmission solenoids are inside the transmission on top of the valve body.


Where is the PCV valve located on a 94 Jeep Grand Cherokee?

4.0L does not have a PCV valve, it uses an orifice in the rear of the valve cover.


Where is the egr valve on a 97 Jeep Grand Cherokee 4.0?

Doesn't have one.


Where is the coolant bleeder vavle on 1999 Jeep Grand Cherokee Laredo?

On a 1999 Jeep Grand Cherokee Laredo, the coolant bleeder valve is typically located on the engine's thermostat housing. It's designed to help remove air pockets from the cooling system during a coolant change. To access it, you may need to remove any components that obstruct your view of the thermostat housing. Be sure to allow the engine to cool before attempting to bleed the system to avoid injury.


How do you open the radiator drain on a 2001 Jeep Grand Cherokee?

Questions with 'Facing your Grand Cherokee Laredo, the pitcock is on the bottom right of the radiator. You should be able to reach around the bottom valance (with the engine cool) and feel the pitcock. It is a small plastic valve and should have a 8" tube (which is too short in my opinion) attached. The valve should turn 3/4 of a turn. If it only turns 1/4 turn you may have to apply slight force.