you can go on line and look for customized Saxophone and look if there's a website where you can go and check of any saxophone strap makers, if not working wait some time and try again in the future, or just print out a picture of yourself and sew or iron it on it will make it easier if you go to any craft store buy some super glue and stick a picture of your face on!
A strap around your neck.No but really, it allows movement in the fingers by taking the weight of the instrument off your hands, and putting it on your neck. It is connected to a loop found on the back of the saxophone, and is often adjustable.
So it doesn't fall off when you're holding it,and because it is too heavy to hold in your arms.
The best place to get a replacement should strap is at the site "Strap Works". They have straps in a variety or materials for bags, purses, camera cases and other item that uses such a strap.
That's a tough one, but I found some custom instrument straps on Etsy. Try this one: etsy.com/listing/86885281/custom-instrument-neck-strap-1-wide-you
Most music stores that sell guitars will also sell guitar straps. However, you may want to consider a customized one with your stage name. These are often available from local craftsmen.
AnswerPlace the strap on the saddle to transport it.
The soprano is much like a clarinet in which you can or cannot have one. However they are a reasonable amount heavier than the clarinet so it would be suggested.
A bra strap is the part of the bra that goes over the shoulders. It's in the same place as the straps of a tank top.
The strap holds your laptop in place so it doesn't move around while you carry the bag.
The 2000 VW Beetle headliner is held in place by a retaining strap. The retaining strap encircles the entire roof. The retaining strap has approximately 20 screws holding it in place. Remove the retaining screws and the headliner will come free.
A first step would be to read and follow the maker's instructions. If you don't have them, ask the supplier. In general, a Beam Strap should be snug, placed on a beam capable of holing the load created when a worker falls, and not placed over sharp edges that can cut the strap. ALWAYS inspect a strap before putting it in place, or hooking off to it. Place the strap as high as you can reasonably place it- lower anchorage points mean you will fall further.
well..... first you should open the straps and place you skateboard inbetween then you close the strap so your top truck is on top of the strap and you bottom truck is under the strap that is how to strap your board to a backpack =)