I was told by a Chevy dealer that it is built in and cannot be removed.
You can disable the anti - theft by getting to the ignition switch and cut the
anti - theft wire. Which in my case on a 2001 Malibu was a yellow wire in ignition bundle.
This wire must be cut while engine is running to fake out the computer that enables the signal to the fuel pump to allow flow to injectors at engine. I have read so many complaints about GM's anti theft problems by too many people and I certainly feel their pain, especially in their pocket books. That routine of turning key to on position and waiting 10 or so minutes gets to be a real pain after awhile. My yellow wire that I cut was routed down behind the radio to a single pole switch with wires attached and switch left in the open position ( same as wire being cut ). The anti-theft light remains on.
what is the cost to repair password for antitheft system chevy malibu 2001?
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
how do I remove a watwr pump on a 2005 chevy malibu
"bulldog.com has a do-it-yourself step by step procedure. I tried it and it worked" Well, I tried it and it took me to a PORN SITE. Not a male, not a lesbian, and not appreciating your "help!"
How do you shut off the anti - theft system on a 1997 chevy malibu?
what year
Remove the retaining cover to your 2005 Chevy Malibu radio. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable.
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
Remove the belt from your 1999 Chevy Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
heating system
To disconnect an alarm system that won't reset in a 2003 Chevy Malibu, you can start by disconnecting the vehicle's battery. Remove the negative terminal first, wait for about 15 minutes, then reconnect it. If the alarm persists, locate the alarm system's fuse in the fuse box and remove it. If the problem continues, consider consulting a professional for further assistance.
Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.