Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light.
If that does not work an OBD 1 scan tool is required.
Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light.
If that does not work an OBD 1 scan tool is required.
Yes, try turning the key on, off, on, off, on and counting the blinks of the check engine light.
If that does not work an OBD 1 scan tool is required.
Yes, the engine computer is the voltage regulator.
Short circuit in your vehicle alarm system. In most alarms, some lights will flash on and off as an indicator of an attempted break in.
You have to drop your tank,it is inside the tank
Yes it does, both the 4.0, and 5.2 I would change at around 75,000-90,000 miles. The timing chain should last for the life of the engine. 200k plus.
Jeep doesn't use an inertia/ reset switch. The fuel system is computer controlled with relays.
hoe do you reset the check engine light in a 1995 land rover
The PCV valve on the 1995 Jeep Grand Cherokee Laredo V6 engine is on the oil filler tube. It is on the top of the engine.
no
The engine light is on when the engine computer has detected a malfunction and set a trouble code.
Every sensor on the engine and transmission can cause the light to come on.
It's the " service engine soon " light to the left of the gas gauge instead of the " check engine " light , like it is on my 1995 Ford Explorer
Turn on the ignition and look at the instruments. You will see the Check Engine Light come on for a few seconds and then go off. If you see the light it is working.
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
www.troublecodes.net Good luck I have a 1995 jdauksz1@charter.net
for the check engine light go to autozone and they will diagnose your engine for free as for the speedometer you will proobably have to replace the speed sensor
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
The check engine light can be reset two ways. 1) If the problem resolves itself, the check engine light will reset itself after a certain amount of cold starts of the car on the on board computer system. 2) You need an OBD reader that has the reset check engine light capability.