Want this question answered?
A medium voltage switch gear is on the low voltage side of the transformer. This medium voltage switch is very cost efficient as well.
If the switch is closed (connected) the voltage across it will read 0V. If the switch is open (disconnected) the voltage across it could be anything, it just depends on what the voltage between the wires going into the switch is.
There is a thing called the resistor box that drops the voltage through the switch leaving the full voltage to run on number 4 of the switch. Locate this resistor and replace, this should fix problem.hope this helps
put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt
no such switch.
The voltage drop should be as close to zero as would be readable by a typical volt meter. If it is measurable you likely have a problem with corrosion or oxidation in switch that is increasing resistance. If you can measure a voltage drop across a closed switch contact, replace the switch. Or the switch is open, try flipping the switch!
A switch that regulates voltage to something.
Look for switch on floor
its on the distributor
Locate the switch and turn it on.
For an ideal switch, there will be no voltage drop across it. In reality, there will be a very small voltage drop, and this will be dependent on how well made the switch is, and what it is made out of.
The full circuit voltage