Between the exhaust header and the catalytic converter.
No switch it has a relay auto turn on
Behind the driver, under the vehicle.
The verb "locate" refers to finding the exact position or place of something. When transformed into a noun, "locate" becomes "location," which refers to a specific place or position where something can be found.
you can't
On the top of the exhaust manifold is where the O2 sensors are located. There is an upstream and downstream sensor on each side of the engine. If the sensor is sensor 1 position 1, the sensor 1 means it is on the side of the first cylinder and position one means it is before the catalytic converter. If the sensor is sensor 1 position 2 it would still be on the side of the first cylinder but after the catylatic converter.
I need to locate the IAT sensor on my 2001 Aurora
how to locate and chage plugs
To change the crankshaft position sensor on a 1999 Oldsmobile Silhouette, first disconnect the negative battery cable to ensure safety. Locate the sensor, which is typically found near the crankshaft pulley; remove any components obstructing access. Disconnect the electrical connector and unscrew the sensor from its mounting position. Install the new sensor by reversing the steps, ensuring it is securely fastened and reconnected before reconnecting the battery.
In transferring position you should measure your position or locate your position then bring it to the compass rose in order to get your position.
did u ever figure it out?
The 2002 Oldsmobile computer is located behind the passenger side dashboard. You will need to remove the passenger side kick plate in order to access the computer.
To replace the camshaft position sensor on a 2000 Oldsmobile Alero, first disconnect the negative battery cable to ensure safety. Locate the sensor, which is typically situated near the top of the engine, and unplug the electrical connector. Remove the mounting bolt(s) securing the sensor and gently pull it out. Install the new sensor by reversing the steps, making sure to reconnect the electrical connector and reattach the battery cable.