0
Passenger side, next to oil pan.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the starter solenoid on a 1989 Chevrolet celebrity?
The starter solenoid is located on the top of the starter.
What is the weight of a 1989 Chevrolet c1500 pickup truck.?
The approximate weight of a 1989 Chevrolet C 1500 pickup truck is 3,700 pounds. Trucks that have been modified will weigh more.
Oil capacity of a 1989 Chevy c1500?
The oil capacity for a 1989 Chevrolet C 1500 truck is approximately 5.5 quarts of oil. The recommended oil type is 10 W 30.
Where is the starter located on 1989 4.3l v6 Chevy blazer?
The 1989 Chevrolet Blazer 4.3 liter engine starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
Where is the radiato drain plug for a 1989 Chevy c1500 silverado?
The radiator drain plug on a 1989 Chevy C1500 Silverado is on the bottom of the radiator.
Where is back up light switch on 1989 C1500?
On a 1989 C1500, the back up light switch is located on the driver's side of the transmission. It is just behind the area that is bolted to the motor.
Where is the starter on a 1989 Chevrolet cheyenne truck 350 motor automatic 1500 series?
The starter should be located at the rear of the engine next to the flywheel on the passenger side. ~ D
How do you locate the number 1 cylinder for timing on a 1989 Chevrolet pick up truck?
Assuming this is a V-8, Chevrolet's #1 cylinder would be the first one in front on the drivers side bank.
What gear oil goes in a 1989 Chevy C1500?
85w90 will be just fine.
What all is involved to replace a starter on a 1989 Chevrolet cheyenne truck 350 motor automatic 1500 series?
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at top of starter Remove mounting bolts Remove starter
Where is the fuel tank on 1989 Chev c1500?
It is on the drivers side under the truck bed.
How do you replace the starter in a 1989 Chevrolet Camaro?
# Disconnect negative battery cable # Raise and support car on jackstands # Remove the brackets supporting the starter # Remove the 2 starter motor to engine bolts and let the starter drop down far enough to allow removal of the nuts attaching the wires to the starter solenoid and battery cable # Separate the starter from the engine
