0
On the 89 grand wagoneer with a 360 it is located on the heater core housing. inside the engine compartment close to the fire wall near the engine. there is a plug that the wires go to that is the resistor on mine.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the location of coolant temperature sensor 1988 Jeep wagoneer limited?
what engine do you have? if it is a 360 it is located on the thermostat housing.
Where is the horn located on a 1987 Jeep wagoneer limited?
On the steering wheel
What size speakers are in a 1987 Jeep Wagoneer Limited?
5 1/2"
What is the brands of strollers to avoid when in the market for a purchase?
The Kolcraft Jeep Wagoneer Limited Tandem JT001 is considered one of the owrse.
Where can you purchase a blower resister for a 2000 chrysler sebring limited?
Check with your local auto parts store. If they can't get it, call the Chrysler dealer.
Where is the thermostat housing on a 1988 Jeep Wagoneer Limited located?
Follow the upper radiator back to the engine. The hose is attached to the thermostat housing on the engine side.
When was Animal Control Products Limited created?
Animal Control Products Limited was created in 1991.
What fuse is the cigarette lighter fuse on a 1989 Jeep Wagoneer Limited?
My owner's manual for my 1988 Grand Wagoneer has a diagram that shows the cigareete lighter fuse to be a 10 amp fuse located 1 tier up from the bottom of the fuse box on the left hand corner. It is apparently the same fuse as for the radio.
Is there a particular geographic location where hurricanes occur?
There is no single location, but they are generally limited to the warm waters of the tropics.
Is Egypt limited or unlimited governent?
limited because in order to sustain control over Egypt it must have limited government who would imagine the disasters if it was unlimited
What is the radar control that reduces weak echoes out to a limited distance from the ship?
receiver gain control
Where is the blower motor resistor on a 1987 jeep wagoneer?
On a 87 Jeep Wagoneer Limited 4x4, 242cid 4.0L, M.O.H.V. - M, it is located under the kick plate on the passenger side. Unscrew the plate and you will see the vacuum motor (which looks like a flying saucer) and to the left of it you will see the resistor. Unplug the four prong wire, and unscrew the two screws holding it in the duct, and lift out. (Takes about ten minutes to remove)
