I think they call it the transmission mount on rockauto.com I replaced the both passenger side ones and am about to do t he drivers side. This site will be of help http://www.ertyu.org/steven_nikkel/neontsbs/2000/09-01-99.pdf
yes you do. jack up under engine, put a block on jack so not to hurt engine, only put enough tension to re move left motor mount .then replace belt,put mount back on, lower jack, then check mount bolts fo tightness. 3.1 Chevy engine in 2000 Malibu!!
There are four engine mounts, one in the front, back, left and right. A real pain, unless you remove the engine to install.
It is on the front of the engine, behind the engine mount bracket.It is on the front of the engine, behind the engine mount bracket.
Loosen the engine mount retaining bolt. Jack up your 2000 Monte Carlo engine. Remove the engine retaining bolt and the engine mount bushing. Put the new engine mount bushing in and reverse the process.
Front of the engine, behind the motor mount.Front of the engine, behind the motor mount.
Two.
Front of engine, behind the engine mount bracket.
do I have to lower the engine to replace the water pump ona 2000 ford focus zetec engine
It is on the starter which is on the front lower side of the engine.It is on the starter which is on the front lower side of the engine.
At the front of the motor attached to the engine cradle.
Lower front left of engine.
The therm is in the housing that connects to the lower radiator hose. It is right below the upper hose where it connects to the engine. You may have to remove the battery. There are 3 bolts connecting the L shaped gasket from the lower hose to the engine that need to be removed. Pull that gasket off and the therm is right there.