At the front of the motor attached to the engine cradle.
Simply raise the car and support the engine on a jack, then unbolt it.
2000 Villager motor mount is located on the cross member dead center front of the vehicle. 2 bolts attached to the cross member pull out towards the alternator as well as the bolt through the mount itself. 17mm if I remember correctly.
3
There is no fixing a broken motor mount. Replace them with a new ones.
You need to support the engine so that the cradle can be removed and the mount can be unbolted and replaced.
There are a total of 3, or 4, if you include the rear cradle mount.
To replace the windshield wiper motor on a 1994 Mercury Villager, start by disconnecting the negative battery cable for safety. Remove the wiper arms by loosening the nuts at the base and gently pulling them off. Next, take out the interior panel covering the wiper motor, disconnect the wiring harness, and unscrew the motor from its mount. Finally, install the new motor, reconnect the wiring, and reassemble the wiper arms and interior panel.
There is no fixing a broken motor mount. Replace them with a new ones.
Front of the engine, behind the motor mount.Front of the engine, behind the motor mount.
There are 3, or 4 if you count the rear cradle mount.
have your motor mount checked my protege did the same thing and it was the front motor mount have your motor mount checked my protege did the same thing and it was the front motor mount have your motor mount checked my protege did the same thing and it was the front motor mount
There is no heavier motor mount available for your vehicle. Inspect the other motor and or transmission mounts for wear. They should not break so easily unless there is some other mount that is bad causing that one to break.