i need direction on how to put together a mainstay corner tower desk
Yes. I found a staples corner computer desk on http://www.staples.com/Staples-Corner-Computer-Desk/product_714651
A computer corner desk is a space saving desk that a person could buy to put their computer on. The desk goes in a corner instead of against a flat part of a wall.
A small corner brace in furniture assembly is used to provide additional support and stability to the structure, helping to prevent the furniture from wobbling or collapsing.
it is in the ski lodge attic red couch in the top left corner sit on it and your spy phone should start blinking click on it then follow further instructions
The best corner computer can be bought at besthomefurniture. The Bush Signature Cabot 60-Inch Corner Computer Desk has a 4-port USB hub, as well as many concealed cabinets and drawers.
Microsoft will periodically send out update notices for Internet Explorer. They usually appear in a box at the bottom corner of your computer screen. Clicking on it will provide a series of instructions.
To change the front corner lamps on a 1988 Volvo 740 Turbo, start by opening the hood and locating the screws or clips that secure the corner lamp assembly. Carefully remove these fasteners and pull the assembly out from the front of the vehicle. Disconnect the bulb socket from the assembly, replace the bulb if necessary, and then reassemble by reversing the steps. Make sure the corner lamp is securely fastened before closing the hood.
Diagonally, from the top corner to the opposite bottom corner.
Measure diagonally with a tape measure from corner to corner of the viewable area only. Doesn't matter if you start on the top corner or the lower corner.
I have looked at the search results for a number for stores that sell corner desks and what I have found is that they all let you know that assembly is required but I have not found any store that provides the service of setup and installation.
To replace the front corner light assembly on a 1992 Volvo 940 GL, first, open the hood and locate the screws securing the light assembly; typically, there are two at the top. Remove these screws using a screwdriver and carefully pull the assembly out. Disconnect the wiring harness from the back of the assembly, then connect the new assembly and reverse the process to secure it in place. Finally, test the new light before closing the hood.
There are instructions in the upper right hand corner.