answersLogoWhite

0

Depending on how many bars of pressure you are talking about and where you live in the world. But generally, copper or galvanised are good options and be sure to use copper compression fittings on the outside and solder joints on the inside if using copper piping.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What are the two mains types of computer program?

Operating systems and application software.


Will the pressure increase or decrease if you put a half inch restriction in a three quarter pipe?

Neither Pressure re mains the same the VOLUME changes along with the VELOCITY


How can the hot water be at a higher pressure than the cold mains in an unvented system?

In an unvented system, hot water can be at a higher pressure than the cold mains due to the presence of a pressure-reducing valve on the cold water supply. This valve controls the pressure of the cold water coming into the system, allowing the pressure of the hot water, which is heated and stored at a higher temperature, to be higher. Additionally, the expansion vessel in the system helps regulate pressure fluctuations by absorbing excess pressure from heating water.


What is the average flow rate of water within a 32mm pipe at UK mains pressure?

30 litres per minute


How do you get water in the boiler?

In the combo boiler for the central heating? You need a small piece of hose (or it might have a permanent connection) to fix to the mains from the boiler. Then turn the taps near the boiler for the mains and the boiler. You want the pressure to be about 1.3 bar


What is the frequency of ripple component in the output inductor filter?

It depends on the rectifier. For a half-wave, it's the same as the AC mains: i.e. 60 Hz mains gives 60 Hz ripple. For a full-wave or a bridge, it's twice the AC mains: 60 Hz mains gives 120 Hz ripple. Three-phase systems are more complicated, so you would need to check in an electrical engineering book.


What is the frequency of ripple component in the output of inductor filter?

It depends on the rectifier. For a half-wave, it's the same as the AC mains: i.e. 60 Hz mains gives 60 Hz ripple. For a full-wave or a bridge, it's twice the AC mains: 60 Hz mains gives 120 Hz ripple. Three-phase systems are more complicated, so you would need to check in an electrical engineering book.


What is the velocity of an average shower head?

The velocity does not depend on ther shower head, however it does depend on the cold mains pressure, a higher pressure will result in a higher velocity, and visa versa.


When would the water mains pressure supplied to a premises be at its highest?

Call your city hall or Water Works for the information of what PSI it is set at.


Your barn water hydrant has very little pressure how do you fix this?

Turn up the mains pressure or replace your water lines if you have galvanised piping, the internal diameter might have been reduced due to rust.


How tall is Ryan Mains?

Ryan Mains is 5' 8".


When was Johnny Mains born?

Johnny Mains was born in 1976.