a resistive load is the same all the time, a tungsten load has an initial surge of current that's higher until the filament heats up and it's resistance increases.
600w
600w - the thicker filament has a lower resistance, which leads to a higher current and thus higher wattage
It depends on the voltage source. watts = voltage * voltage / resistance and amps = voltage / resistance example 1: To produce 600W from a 120V source, you need a resistor of size 120V*120V/600W = 24 Ohm. This would pull 120V/24 Ohm = 5 amps. example 2: To produce 600W from a 240V source, you need a resistor of size 240V*240V/600W = 96 Ohm. This would pull 240V/96 Ohm = 2.5 amps.
Obviously not. It would blow the bulb by 600W! <<>> Yes you can use a 60 watt light bulb in a lampholder that is rated a 660 watts. The rating given to these lamp holders is the maximum amount of wattage that can be applied to them safely.
According specifications listed Output Wattage 600W
cp8a lubriplate is an equal to the 600w super
600w
600W
600w - the thicker filament has a lower resistance, which leads to a higher current and thus higher wattage
600W
600W
It depends on the voltage source. watts = voltage * voltage / resistance and amps = voltage / resistance example 1: To produce 600W from a 120V source, you need a resistor of size 120V*120V/600W = 24 Ohm. This would pull 120V/24 Ohm = 5 amps. example 2: To produce 600W from a 240V source, you need a resistor of size 240V*240V/600W = 96 Ohm. This would pull 240V/96 Ohm = 2.5 amps.
yes
600w and do not over fill.
Obviously not. It would blow the bulb by 600W! <<>> Yes you can use a 60 watt light bulb in a lampholder that is rated a 660 watts. The rating given to these lamp holders is the maximum amount of wattage that can be applied to them safely.
According specifications listed Output Wattage 600W
You are confusing electrical potential (Volts) and power (Watts). The equation for power (watts) is P = VI where V is volts (a measure of electrical "pressure") and I is current in amperes (the rate of flow of electricity). If the system is 120V and the power used is 600W then the current used is 5A. If the system is 240V and the power used is 600W then the current used is 2.5A.