You are confusing electrical potential (Volts) and power (Watts).
The equation for power (watts) is P = VI where V is volts (a measure of electrical "pressure") and I is current in amperes (the rate of flow of electricity).
If the system is 120V and the power used is 600W then the current used is 5A.
If the system is 240V and the power used is 600W then the current used is 2.5A.
800 000 Watts / 600 Volts = 1333.3333333 Amps
600 This depends on the voltage Voltage x Amps = Watts ex. At 120 volts 5 amps WILL BE 600 watts But at 110 Volts (Some house voltage), it will be 550 watts And at 277 Volt (commercial-Industrial Voltage), it would be 1385 Watts If you know Watts (Like a 75w Incandescent Lamp) and the Voltage: Watts / Volts = Amps So 75w / 120v = 0.625a The last would be Watts / Amps = Volts 600w / 5a = 120v
volts times amps = watts
A transformer does not use, it transforms voltage from one value to another. The output amperage is governed by the connected load. If the load wattage is higher than the wattage rating of the transformer then either the primary or secondary fuse will blow or the transformer will burn up if the fusing is of the wrong sizing. The maximum primary amperage can be found by using the following equation, Amps = Watts/Volts, A = W/E = 600/120 = 5 amps. The same equation is used for the calculating the maximum secondary amperage, A = W/E = 600/12 = 50 amps.
If you are using a 120V power supply, a 600 watt floodlight will draw 5 amps of current (600 watts ÷ 120 volts = 5 amps). Remember to always check the specific electrical requirements of your floodlight to ensure the correct amperage.
Watts and Volts are two distinct types of measurement.
Amps, volts and watts are interrelated, but you need to do a little math. Amps * Volts = Watts
Zero. Watts is the product of Amps x Volts. As you can see an amperage value is needed. Voltage = Watts/Amps. Volts = 200/? 20 volts
4 volts and how many amps? Watts = amps x volts. It depends on the amount of current (in Amps) flowing at 4 Volts... See Ohms Law: Watts = Volts x Amps If you have 2 Amps flowing at 4 Volts you are dissipating/consuming 8 Watts. If you have 10 Amps flowing at 4 Volts you are dissipating/consuming 40 Watts.
P=UxI so I=P/U so 600/115=5.21 A ignoring losses
To determine how many amps are in 115 volts, you need to know the power (in watts) being used. The relationship between volts, amps, and watts is given by the formula: Watts = Volts × Amps. Therefore, to find the amps, you can rearrange the formula: Amps = Watts / Volts. For example, if you have a device that uses 1150 watts, you would have 10 amps at 115 volts (1150 watts ÷ 115 volts = 10 amps).
Volts don't make power. Watts do. Watts = (volts) x (amps) 1 horsepower = 746 watts