answersLogoWhite

0


Best Answer

#1 is front cylinder, distributor rotates clockwise, firing order is 1342, timing is 6 btdc

User Avatar

Wiki User

โˆ™ 2008-02-15 00:19:24
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Mazda b2000 1986 distributor wiring
Write your answer...
Submit
Related questions

What would cause no spark to a coil in a 1986 Mazda b2000?

I have replaced the coil and distributor cap.


What carburetor is on a 1986 Mazda b2000?

I believe the carburetor is a Mikuni. I have a 1986 B2000 myself.


What is the engine oil capacity for an 1986 Mazda B2000?

The engine oil capacity for a 1986 Mazda B2000 is 4.1 quarts.


When changing the oil on a 1986 Mazda B2000 How many quarts do you put in?

4 quarts. I own a 1986 B2000.


Where is tank fuel gauge for 1986 Mazda pick up B2000?

where is fuel gauge and how to replaced for a 1986 Mazda pick up B2000 please let me know thank you


Where can you find a Bed cap for 1986 Mazda b2000?

As of 2014, there are a few places where you can find a bed cap for a 1986 Mazda B2000. This part can be found at local body shops and auto part stores and through Mazda.


What is the firing order for a 1986 Mazda B2000?

firing order is 1, 3, 4, 2 for a 86' B2000


What is the spark plug wiring order for a B2000 Madza 1986?

the wiring order is 1342


What are the valve lash specs of a 1986 Mazda B2000?

0.012


What is the wheel size on a 1986 Mazda b2000 pickup truck?

The 1986 Mazda B2000 pickup truck has 14"x5.5" rims. The OE tire size is 205/75R14, and 195R14 tires also fit ideally.


Is a 1988 Mazda B2000 a 4 cylinder?

Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.


Free online Haynes Repair Manual for a 1986 Mazda B2000 truck?

Yes


How do you set the points on a Mazda B2000 1986?

This truck DOES NOT have points!!You would have the standard rotor cap and distributor for electronic ignition.Just buy new cap/rotor install and DONE.Points have not been on vehicles for YEARS.


Where is the Ignition Module located on 1986 Mazda B2000?

Inside the distriburator after you remove the rotor button.


Where is the engine temperature sensor located on 1986 Mazda b2000 truck?

under the termostat housing.


What is the correct way to wire the ignition coil on a 1986 Mazda B2000?

Chiltons Mazda trucks manual has the picture and explanation.


Where are the timing marks on a 1986 Mazda b2000?

the timing marks for that year Mazda are on the crank pulley and corresponding marks are on the timing belt cover.


How do you rebuild a carburetor for a 1986 Mazda b2000?

Buy akit - comes with instructions and gaskets


Do 1986 Mazda B2000 have locking rear end?

It has a limited slip differential.So no to your question.


Your 1986 Mazda b2000 runs fine but will not idle any suggestions have new carb plugs cap rotor fuel pump?

I have an 89 Mazda b2200 and all i did was mess with the timing and it started to run better,a but a friend suggested that I pull the distributor shaft and turn it a notch.


Repair for 1986 Mazda b2000 blown head gasket?

change the head gasket. tard


Could you use automatic transmission fluid as 1986 Mazda b2000 clutch fluid?

NO, Break Fluid Only


Could you use automatic transmission fluid as 1986 Mazda b2000 clutch slave cylinder fluid?

use brake fluid


Can anyone adive of where to locate a Vacuum diagram for 1986 Mazda B2000 1998 CC or 2.0 liter engine?

from Mazda or you could try your local library they often have workshop books.


How much horsepower does your 1986 Mazda B2000 have?

The 86-89 B2000 put out 86 hp @ 4800 rpm and 120 ft-lbs @ 2800 rpm. See the attached link for additional specifications.