answersLogoWhite

0

Mercedes-Benz 240d motor noise

Updated: 9/14/2023
User Avatar

Wiki User

11y ago

Best Answer

bearings are going. Need to oil them. SOon you will blowing fuses because the excess drag in amperage will exceed the 8 amp fuse and blow it

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Mercedes-Benz 240d motor noise
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1980 240d Mercedes Benz blower motor circuit diagram?

email me at jacks1456@yahoo.com and I will try to send you the schematic


How do you change the headlight on 240D Mercedes?

How do you change the headlight on a 240D mercedes?


Which is the toughest car?

Mercedes 240D.


What is the binary equivalent of 240?

240d = 11110000b


1980 240d oil capacity?

The oil capacity of a 1980 Mercedes 240d is 5 quarts. This include the oil needed to fill the oil filter.


I need radio code for 1977 240d Mercedes?

The radio the 1977 240D is equipped with does not require a radio code. If you have an aftermarket radio, you will need to contact the manfucaturer.


Where would you find a diagram for a timing chain for a 1980 Mercedes 240D?

Try a bentley manual. I guess it could not have the "240d" specifically. A parts sight may have an exploded diagram.


How do you fix the window regulator for a 1983 Benz 240d?

bring it to the dealer


Where is the fuel pump located on a 1982 Mercedes 240d?

The fuel pump on a 1982 Mercedes 240D is located inside the fuel tank. A replacement fuel pump can be purchased at any auto parts store.


How do you fix a injector leake on a 1980 240d Benz?

Replace the O-ring on the injector.


What is the buttonswitch under the radio by the shifter for on the 1974 Mercedes 240D if you pull it out a light comes on then when you push it back in the light goes off. Nothing else happens.?

I own a 1975 MB 240D. The knob your asking about works my rear window defroster.


How do you change the injectors in your 1975 240D Mercedes?

Unscrew them , & repalce , usually only the nozzle is replaced .