use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
Which of the following is a correct procedure for the operation of a microscope? First, put the specimen into focus using a low power lens, then switch to a lower power lens if needed.Remove and add slides while the high power lens is selected.First, put the specimen into focus using a low power lens, then switch to a higher power lens if needed.Use the fine focus knob with the low power lens and use the coarse focus knob with the high power lens
the diameter of the high power field microscope is 500 micrometers
the high power lens uses a lot of light scorce so it could burn your eyes
The Dissecting Light Microscope range of magnification is 20x to 80x. The Compound Light Microscope ranges from 40x to 1000x -40x Scanning -100x Low Power -400x High Power -1000x Oil Immersion
For low power you can use the coarse adjustment and fine adjustment for high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
The coarse adjustment knob should never be used when viewing in high power with a compound microscope. When in high power, use the coarse adjustment (the knob smaller than the coarse adj.) to more accurately focus on the subject.
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
The "base" supports the microscope. The "arm" holds the eyepiece, bodytube, fine and coarse adjustment knob, nosepiece, and the high and low power objective which connects to the "base. "
The function of a microscope's coarse adjustment knob is to improve focus on the object under study by adjusting the lens. Unlike the fine adjustment, coarse adjustment moves the lenses quickly.
Coarse Adjustment
high-power lens
I assume you would use the fine adjustment knob for high power objectives.
First of all, one should never call it high power, it is morecommonly called the "high objective", yet that is not what this question is asking. To answer the question: You use the fine adjustment knob. This knob should be located near the coarse adjustment knob, on the opposite side of the microscope (at the same height as the coarse adjustment knob), or even as a separate knob protruding from the coarse adjustment knob. The fine adjustment knob is smaller in size. You should never, ever use the coarse adjustment knob under the high objective, you could scratch the microscope slide, cover slip, high objective lens, or in a worst case scenario break the high objective lens.
On a the microscope I use, the ocular (eyepiece) has a magnification power of 10x. The 'low' (or 'scanning') objective lens is 4x, the 'medium' has a power of 10x, and the 'high' has a power of 40x. Multiply the ocular by the lens you're using to get your 'total magnification.' TIP: Only use the coarse adjustment knob while on 'low' power, then use the fine adjustment. Why? If you use the coarse adjustment knob on 'medium' or 'high,' there's a good chance you'll crack your slide. -BugCrunch
It can burn your eye.