To avoiding the noise signal effect.Because the modulation is a technic which providing a high characteristic to transmitting the signal on long or short distance.Because the modulated signal received as high bandwidth,high performance of received signal and the modulation Technic is provide a less hight of antenna in wireless transmission which is expressed in the term :(hight of antenna=λ/4).
It is a direct-current amplifier in which the dc input signal is filtered by a low-pass filter, then used to modulate a carrier so it can be amplified conventionally as an alternating-current signal; the amplified dc output is obtained by rectifying and filtering the rectified carrier signal.
LENZ LAW gives the direction of induced current.
In an incandescent light bulb the wire that gives off the light is called the Filament.
it gives a nice pleasurable experience
Modulate Demodulate
modulator-demodulator
modulate and demodulate
Modem stands for MOdulate DEModulate it takes digital information from your computer and turns it into sound (the MOdulate portion) and turns sound into data (the DEMod part)
No, it is not an adverb. The word modem (from modulate-demodulate) is a noun, a device that changes electrical impulses into sound, and vice versa.
A modem. Short for MOdulate-DEModulate.
"MODEM" stands for "modulate/demodulate" The modem changes digital signals into analog tones that can be sent across a telephone wire.
MOdulate/DEModulate. It converts digital computer signals into analog ones for transmission over analog telephone lines, and then converts the signal back into digital on the other end.
Modem is short for MODulate/DEModulate. It modulates a signal to send across a serial wire, and demodulates the signal that comes back.In other words, a modem is both an input AND an output device.
BPSK is a modulation technique. It is used to modulate and demodulate the required signal. It can be virtually implemented in MATLAB. But to understand its physical behaviour, it needs to be implemented on FPGA board.
The photos are stored in a propriatary format to the camera. Only the camera can modulate and demodulate the file to and from a computer.
1. To MODULATE (convert) the digital signals from a computer into analogue signal to enable it to be carried through the telephone line. 2. To DEMODULATE (convert back) analogue signals from a telephone line into digital signal to be used in computer.