Want this question answered?
Work output is less than or equal to the work input. This is the law of conservation of energy.
A buffer amplifier of unity gain is generally used when you need to islolate the source.Connecting a source to an amplifier, can have an affect on the original signal. A buffer amplifier stops the signal being affected by the subsequent amplifier sections. The input to the buffer is matched to the signal impedance.
Phil's problem with places like New Hampshire, Fargo, El Paso and Sacramento is that he is not a world traveler and most of his data input is from Pennsylvania based sensors.
Two pairs of Infrared LEDs are used as motion sensor detector. The first one is wired to emit LED and the second is wired to transmit a signal when it receives an infrared input. this infrared is reflected back to the receiving LED and then the signal is produced. This signal can be used to open sliding doors, turn on a light or set off an alarm.
Its a long shot but... If you have a leak in the exhaust before the oxygen sensors, the sensors will think the engine is running lean. The computer will compensate (from incorrect input data) by increasing fuel delivery, causing the air/fuel mixture to go rich. If the engine runs super rich the exhaust will be black, and very noticable when you accelerate.
if the speedometer works off of an input wave (sinusoidal signal) you would think the signal generator would be a source of reference
Counter type ADCOne of the simplest types of the ADC is the Counter type ADC. The input signal of the ADC is connected to the signal input of its internal comparator. ADC then systematically increases the voltage on the reference input of the comparator until the reference becomes larger than the signal & the comparator output goes to zero.Fig.1 Counter type ADCDinesh Kumar - http://harshit.org
The input and output speed sensors are the two wire sensors on the front of the transmission case. The input is closer to the engine.
The controller processes the input information from sensors.
It is an input, sensors are always inputs.
It is an input, sensors are always inputs.
Force transducers are also commonly recognized as force sensors. A force sensor is described as a transducer that converts an input mechanical force into an electrical output signal.
the input signal is carried to CPU by having a binary numbers.
They are the two wire sensors on the front of the transmission case. The input is closer to the engine.
amplifier will strengthen da small input signal n amplifies it
Yes. It converts what are you recording in to electric signal and this signal put INTO a computer.
They read the speed of the input and output components of the transmission.