answersLogoWhite

0

A possible solution to your problem is to check your gas supply, it could be leaking or in need of a change, a plasma cutter will not work without a steady supply of the gas you are using, another solution could also to inspect the parts on your plasma cutter and make sure they are in full working condition.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Kari checked her pluse and counted 21 beats in 15 seconds so how many will be there in 30 seconds?

42.


Where is the newegg.com?

http://www.newegg.com/ I just checked a few seconds ago and it is there.


My engine turns over but wont start. When it did start the engine will run for like twenty seconds then it would shut off. Does my timing chain need to be replaced or does the timing need adjustment?

Well, if it ran smooth for the 20 seconds then timing has nothing to do with it. Sounds like a fuel shortage. Have the pump checked, and also the filter.


How long is the song one shot by jls?

3 minutes and 48 seconds (checked on you tube)


How long does it take Jose Reyes to run from home to first base?

Last I checked, 3.2 seconds.


My ford capris engine will start run for 5 seconds then it dies?

You should probably get that checked by a mechanic.


What could cause the temperature warning light to come on after about 15 seconds from starting on an A4 2.6?

Low coolant level or faulty coolant level senser. Did a radiator flush and replaced water bottle with sensor... still nothing.


Why does your tercel starts then runs for about 10 seconds then dies?

Go have Your Fuel Pump REPLACED


How long will it take to drive in 2.3 seconds from Memphis to nashville?

It will take 2.3 seconds to drive 2.3 seconds. This is regardless of your starting and ending points.


Why is my smoke alarm chirping every 30 seconds?

Your smoke alarm may be chirping every 30 seconds because the battery is low and needs to be replaced.


Why my 1991 4.3 s10 starts for about 3 seconds and shuts down?

Your 1991 4.3 S10 starts for about 3 seconds then shuts down because it is faulty. Take it to mechanic to have it checked.


Why does frig cycle off only seconds after it cycles on?

Fridge timer probably needs to be replaced!