0
Name the part in braking system that holds the fluid under pressure?
Wiki User
∙ 14y ago
teri maa de lun
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is a brake accumulator?
A brake accumulator is a device that holds brake fluid at a very high pressure. It is an important part of a proper brake system.
The function of power steering fluid Reservoir?
It holds or reserves the fluid until it is needed by the system.
Is the master cylinder part of the 4 6 or 8 ect cylinders of your engine or is it different?
The Master Cylinder is part of your Braking system. It is usually located on the Firewall of your car and holds the brake fluid which allows you to stop by pushing fluid against the caliper on your brakes when you put your foot on the pedal. The cylinders of an engine are usually referred to as combustion chambers, or simply the engine block.
How do you repair a soft brake pedal on a 1990 silverado after replacing front padsrear shoes and wheel cylinders?
The 'soft' brake pedal is likely a result of air entering the braking hydraulic system when the wheel cylinders were removed and replaced. Basically anytime a brake line is removed it is possible for air to enter the system. You will need to 'bleed' the air out of the braking system by having some other person pump up the brakes and hold pressure on the brake pedal while another person opens the bleed valve on the back side of the wheel cylinder. When the valve is opened fluid (and hopefilly air) will escape through the bleed valve and the pedal will go to the floor. The valve must be closed while the person in the vehicle holds the pedal down. Top off the brake fluid reservoir and proceed to the next wheel and repeat the procedure for all wheels. Ultimately, the system will only contain fluid (and no air) and the pedal will be hard.
How do you pressure check a car radiator for leaks?
You attach a pressure test kit to where the radiator cap goes, and pressurize the system. If it holds pressure, it's good.
What is the fluid in the cell that holds organelles in place?
The answer to this question is Mitochondria.
Where does the hose go that connects the nozzies on your washer system in your 66 mustang?
It goes to a bag hanging on the fender wall that holds the washer fluid.
Hydraulic fluid capacity on a 1999 ford 555e backhoe?
The book says the intire hydraulic system holds 36 gallons and the tank holds 28 gallons. This is from the manual of a 1998 555E I purchased.
How much fluid does a manual transmission hold?
The amount of fluid a transmission holds varies from vehicle to vehicle. To run properly, the average American vehicle holds anywhere from 2 to 4 quarts of transmission fluid.
What is the radiator fluid capacity in a 97 delta 88?
what is the radiator capacity on my 97 delta olds with a 3800 series engine The radiator only holds about 3 to 4 qts. The entire cooling system holds about 12 qts.
What is the membrane of fluid that holds the fetus in the mothers womb called?
The membrane is called the Amniotic Sac, and the fluid is the Amniotic Fluid
Why would a 1992 Corsica not blow warm or hot heat if you have changed the heater core and themostat and flushed the whole system?
Did you bleed the system making sure that there is no air in the system. Check the rad cap to ensure that it holds the pressure
