0
Moving the utility meter is a complicated job in as much as you have to know wire sizes, ampacity of wires and proper electrical workmanship. Such a project should be left to a licensed electrical contractor to take out the proper permits and call for proper inspections. By taking this route it will leave you confident that if any mishaps happen to the installation down the road your insurance company will be behind you 100%.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you write application for removing electric billing meter?
You will need to send the application in to your local electrical company. Make sure to give good reasons why the meter must be removed.
My electricity meter has stopped spinning around how do i start it again?
What is a "hydro?"why did it get shut offPay the bill if it is outstanding.
What is a tilt meter used for?
to see anything if it is level johnathen aguon :) that is a very basic understanding. a tilt meter is used on volcanoes to identify any deformation due to pressure from magma build up. if the tilt meter says that the volcano has moved/bent under pressure, it means that the volcano is probably going to erupt. although, you would need to test the silicon and water levels if you wanted to know whether it would be explosive or not. rk
Does an electric furnace need an outside air intake?
No, an electric furnace does not need an outside air intake. For oil and gas furnaces an air supply is needed. It is called combustion air. It is needed for complete combustion of the fuel and not use the heated air that is in the house. Today's homes are built as a sealed unit to stop infiltration air from leaking in and costing the home owner more money to heat the home. Many installations use a motorized damper that cuts off the air supply when the furnace is not operating. This prevents a draft through the vent from the outside of the house when other extracting devices are operating.
Can you use single phase kwh meter for three phase load?
No. For three phase, you need a minimum of a two element meter.
You think somebody is using your electric supply?
You would not be the first person to have someone else tap into your electric power. If you are in a detached house, it is fairly easy to find out. Turn off everything in the house. Leave the circuit breakers on. Have someone stand outside by the meter. See if the meter still runs. (You may need to turn off the breaker to the hot water.) If the meter is still running when nothing in the house is turned on, you can call the power company to come out and check.
How do you write application for removing electric billing meter?
You will need to send the application in to your local electrical company. Make sure to give good reasons why the meter must be removed.
What equipment do you need to charge an electric car?
An electric car can be charged in your yard. It is suggested that charging take place outside as hydrogen gas is vented during the charge. A plus is all you need for most cars.
What do I need to consider when choosing between an electric or a manual treadmill?
When you are looking for a electric treadmill you will have to worry about a plug and may be harder to move. A manual treadmill is better for exercising and can be moved from room to room.
What is HOTcrane?
Hot Environment Cranes / Electric Overhead Cranes are used in metal refineries where heavy loads that are at a high temperature need to be moved around.
How do you get a meter?
you need to add two feet to get a meter
Does a motor have electrical energy in it?
An electric motor need to be supplied electricity to operate. It can be made to generate electricity if turned by an outside force when set up correctly.
Need find ESID meter number to a house.?
ESID stands for Electric Service Identifier, and it is not locatable on your physical meter. Best way to find it is by looking on your electricity bill or by calling your local utility/retail energy provider. Depending on your local utility, the number can vary in length. I live in Houston, and mine is 22-digits long.
Why the solar panel power cannot be transfer to the meter?
Solar panels are direct current (DC), the electric in the meter is alternating current (AC). You need a special transformer to convert from direct to alternating. This usually has to be done since everything in your house usually runs on alternating current.
How would one recalibrate a flow meter?
One can recalibrate a flow meter by having a company or owning a flow meter supplier or using a flow meter lab. No matter what type of flow meter they need to be checked to see if they need to be recalibrated regularly.
How do you convert running meter to cubic meter?
how we can convert running meter to cubic running meter To get cubic meter, you need to know the length, the width, and the height. Multiply those three together to get volume in cubic meters. You can't get cubic meter just by knowing one dimension such as running meter. You need all three dimensions.
why do circuits need fuses?
Any electric circuit need to be equipped with electric fuses to protect the electric appliances or any electric/electronic equipment from damage due to unexpected electric current sudden or transient increase.
