so go to the parts store and get them
changing the thermostat in a 1991 geo metro 1.3 liter
It is inside the part where your upper radiator hose is fastened onto the motor.
The thermostat is under the top radiator hose. Remove the radiator hose at the top of the engine, below the hose flange sits the thermostat. just pull it out and replace it with a new one, then replace the hose over it. hope this waas the help you wewe looking for.
On my 91 Lsi (1ltr 3cyl) the thermostat is directly under the distributor cap. Follow the upper radiator hose from the radiator to the engine block, under the distributor. The hose is connected to the thermostat housing, which is connected to the engine by two bolts. If you replace your thermostat don't forget a new gasket.
The heater inlet hose on a 92 Geo Metro is located in the rear of the engine compartment. It runs through the firewall and connects to the heater.
Were can I buy a throttle cable for a 97 geo metro
bottom radiator hose housing
The thermostat on a 1995 Geo Prizm LSI 1.8 liters is located at the end of the rad hose. Follow the rad hose connected to the engine.?æ
On the radiator you have a top hose and a bottom hose. Look at the bottom hose and follow it to where it attaches to the block. Unscrew the two bolts. There is the thermostat.
It is connected to top radator hose on block
Low pressure line\ Larger hose from the compressor
Can you swap a 93 Geo metro manual transmition with a 95 Geo Metro