The Junk Yard.
== == u need to lift the license plate up
My 1998 ford explore eddie bauer the code is on the computer module in the rear jack compartment if yours is the same you will need a flashlight to see it.
Need to know what the problems are.
you will need to bypass the amps in the passanger side rear of the vehicle if its the Eddie Bauer edition.
Need to know what about the dash board lights.
hello, i own a 99 Eddie Bauer and if they are the same motor which i think they are then your plugs are on top of your engine heads but below your coil packs. you will need to take the one screw out of your coil pack and your plugs are under them.
you can engage the 4 wheel drive with the vehicle in neutral, then make sure you lock the hubs manually on the wheels. turn the dial on the hub caps of the front wheels to lock, when not in 4 wheel the wheels need to be in free mode.
Either buy the R-12 off eBay or use Freeze 12..................
As a safety precaution if you get into an accident or you run out of gas there is a switch on the gas pump that you will need to reset if its tripped. I found this out when I ran out of gas... On the passenger side of the Ford Bronco (I have a 1994 Eddie Bauer V8) is the fuel pump reset switch. It is located INSIDE the bronco BEHIND the foot panel. If you were sitting in the passenger seat, it would be the panel next to your right foot. You may need to pull the panel off a little to get your hand in behind it. Just feel around and you will find the reset button. Push it down and you're good to go!
If you are messing with the timing chains, you will need special tools to do the job. Give us more info.
Yes the timing chain position marks for engine 4.0 ford explorer eddie bauer
Its either in need of transmission fluid a fluid change or the bands are strechted