answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Need to run a 20 amp breaker 225 ft for a pool pump what gauge wire do i need?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Breaker trips after running pool motor about 8 hours the timer was changed the receptacle was changed but you noticed a little bit of rust on the plug to the pool motor should that be changed?

Pool motor is overheating and or a short in the motor. You need a professional pool tech to troubleshoot.


Why has your In-ground pool suddenly started pouring water down the pool pipe down your driveway as if you had the gauge in the waste mode instead of the filter slot which it is in?

Personally, I'd call the pool company. There are things that need professional fixing.


What do I need for my pool aerobics class?

You need water slippers to keep from slipping on the bottom of the pool floor.


Need to find a gfci pool outlet?

Do you need to find the outlet at a hardware store, electrical store or around your pool area? At your pool area - GFCI's can sometimes be found around the pool equipment pad. Sometimes they are located just off the deep end of the pool at the edge of the deck straight back from the pool light if your pool has a light. However these fixtures do not have any access to an outlet. It is usually just a GFCI fixture. GFCI's can sometimes be found in shrubbery surrounding the pool. You just have to hunt for it in those locations. And there are the instances where no GFCI is provided. There may also be a GFCI in the circuit breaker box but this one will not have an outlet. What is your need for an outlet? If you have a pool light that does not have a GFCI in the system you then need to call a qualified swimming pool electrician or a qualified pool tech to install one. There are special requirements for this application.K


Do you need a pool alarm for a soft round pool?

no


Do you need a permit for a blowup pool in union beach?

You may need a permit to "blow up" a pool within the city limits or anywhere. However, if you are inflating the pool you probably do not need a permit.


Installation for hayward motor to pump on swimming pool?

Not aware that Hayward made motors. You need the pump seal, gaskets or orings and the tools to remove and reinstall the motor and the seal. The electrical connections and power need to be removed and or turned off at the circuit breaker.


When to backwash a pool without a pressure gauge?

sometime they dont be cleaning the pools out but they need to start i mean like that is nasty if its already clean then put a cover over it


What should you do if you have an above-ground pool with a sand filter and the pressure gauge is only reading at 5 but you changed the sand in the filter and it still won't raise the pressure?

You may need a new pressure gauge. They are inexpensive and can be found at any place that sells pool products. OR That may be all that you are going to get out of the system you have.


Do you remove your pool sweeper when you shock the pool?

You do not need to remove it.


I just recently had a swimming pool built for my kids. What supplies will I need in order to maintain the pool and keep it safe for them?

The most important items you will need are the pool chemicals for maintain the water quality. You will also need a pool vacuum, pump and filters.


Do you need a permit for a pool?

You need a permit to build one in most populated areas. You need a permit to run a public pool. You don't need a permit to operate a private home swimming pool.