0
Brake Lights NOT WORKING
Without being able to do a "hands on" troubleshooting of the circuit, no one can tell you the specific cause for this problem. So, the following "generic" answer is the best I can do to help.
There could be several causes, some of which include:
- The fuse [or circuit breaker] which protects the circuit is "blown," thus "opening" the circuit, preventing the flow of electricity.
- The brake light switch is not properly installed or adjusted properly.
- There is a "bad" electrical connection, anywhere within the brake light circuit. This could include: corrosion inside of one or more of the wiring harness connector contacts, or corrosion where ground wires are screwed to the body sheet metal [the body sheet metal is grounded to the battery negative terminal, and thus acts to return current flow to the battery].
- One or more of the conductors has been broken or cut, thus "opening" the circuit, just like turning off a switch.
There probably other reasons which do not come to my mind at this point. Good luck.
What else can I help you with?
Where is the relay located that controls the tail lights and interior lights on a 2000 Mitsubishi Mirage?
The relay that controls the taillights and interior lights on a 2000 Mitsubishi Mirage is in the driver's side fuse box. It is to the left of the steering wheel in the dash. One thing to note about this vehicle is if a brake light burns out, the car might also lose the dash lights or interior lights. Check the brake lights before replacing a fuse that might not need replacing.
Radio code for 2000 Mitsubishi mirage?
4618
How do you change brake pads on a Mitsubishi mirage 2000 model?
To change the brake pads on a 2000 Mitsubishi Mirage, first, lift the front or rear of the vehicle and secure it on jack stands. Remove the wheel and locate the brake caliper; unbolt it and slide it off the rotor. Remove the old brake pads, compress the caliper piston using a C-clamp, and then insert the new pads. Reattach the caliper, replace the wheel, and lower the vehicle before testing the brakes.
Como instalar alarma para el carro?
Como instalar alarma ORIGINAL DE MITSUBISHI MIRAGE 2000 Como instalar alarma ORIGINAL DE MITSUBISHI MIRAGE 2000
How do you align timing marks on 2000 1.8 Mitsubishi Mirage?
timing marks 1.8lt Mitsubishi 2001
Does a 2000 Mitsubishi mirage have a interference motor if timing belt goes?
Yes.
Where is the transmission filter located on a 2000 Mitsubishi Mirage?
Inside the pan of the auto ....
Where is the EGR valve located in a 2000 Mitsubishi Mirage?
Inside the throttl body.
Where is the fuse box location on a 2000 Mitsubishi mirage?
The fuse box in a 2000 Mitsubishi Mirage is typically located under the dashboard on the driver's side. You can find it by looking to the left of the steering column, near the brake pedal. There may also be an additional fuse box located in the engine compartment, near the battery. Always refer to the owner's manual for the exact location and detailed information.
Where Is your Iat sensor located in a 2000 Mitsubishi mirage?
The 2000 Mitsubishi IAT sensor can be found on the right side of the engine. The sensor will be just below the head deck.
How do you remove the rear view mirror on a 2000 Mitsubishi Mirage?
To remove the rear view mirror off a 2000 Mitsubishi Mirage first pop off the plastic cover place on the body of the mirror. Than proceed to unscrew the mounting screws.
Timming a 2000 Mitsubishi mirage 1.8 liter?
I need to see a photo pitchure of the timing alighnment marks,for the crank and cam shaft alighnment for a 2001 Mitsubishi mirage 1.8 liter engine
