answersLogoWhite

0

The relay that controls the taillights and interior lights on a 2000 Mitsubishi Mirage is in the driver's side fuse box. It is to the left of the steering wheel in the dash. One thing to note about this vehicle is if a brake light burns out, the car might also lose the dash lights or interior lights. Check the brake lights before replacing a fuse that might not need replacing.

User Avatar

Wiki User

11y ago

What else can I help you with?

Trending Questions
Why dont your turn signals and emergency signals work? How can you tell if your 2004 Saturn Vue engine has the manifold drilled and tapped for the air check valve and whether or not it has an EGR port on the inner head? What number fuse do you change for a cigarette lighter on a Ford 2002 Expedition? How do you replace the headlights on 1993 Chrysler Town and Country Minivan? Why do you smell a strong gas smell out the tailpipe? What pressurizes the air entering the intake manifold to improve the engine performance? Is speedway gas better then others? How do you tighten the serpentine belt on a 2002 Kia Sedona? How could a fire start all of a sudden after running car for an hour and after driving I started again to see if battery held charge and 2mins later flames happen from under breather. Fuel leak maybe? What is the spark plug gap for a 1977 25HP Evinrude outboard motor? How do you reset service lamp on 1999 Holden Commodore? Why does my Briggs and Stratton 3.5 HP lawn mower engine run for 2-3 seconds and then quit It starts again when primed but will continue to stop? What does bosch oil filter 3330 fit? How do i fix the Egr valve in a 1997 Pontiac transsport? Where is the fuse box on a 1997 VW Cabrio? Where is the voltage regulator located on a 1991 phazer 480 snowmobile? How do you replace an alternator on a 2001 Hyundai Tiburon? What is happening when your 99 dodge durango shifts out of over-drive on the highway and the trans temp comes on Is the transmission going out? What type of fluid does 1991 Mitsubishi mighty max manual transmission use? Why do catalytic converters have a large surface area?