An ohmmeter is an electrical instrument that measures electrical resistance, but instead of hairsprings to supply a restoring force they used conducting of the first pair of leads and their contact resistances is ignored by the meter.
Capacitance is measured in Farads. "The unit... in ohm and meter" does not make sense.
Ohm meter is basically a series combination of resistances and galvanometer and source of current .Used to determine unknown resistance.
If you place an OHM meter across a resistor, it will read resistance. An OHM meter set to read voltage will read any voltage present. So, if you pick up a resistor, connect it to a volt meter, in theory, no voltage will be present. Unless you're feeding some sort of electricity through it. I'm certainly not an electrical engineer, I do however use a volt/ohm meter occasionally. A volt/ohm meter is a dual/multi purpose piece of equipment.
If the meter is sensitive enough and there is a resistance between the neutral and ground then the meter should be able to detect it.
ohmmeter has it's own power supply
An ohm meter doesn't put out enough voltage, you need to use a megger.
To ohm out a motor one would use an ohm meter. If one does not own or can not obtain a meter, the motor can be taken to a shop and ohmed out there for a fee.
you use an ohm meter
It stands for digital volt-ohm meter
Ohm Meter
Continuity tester, volt meter, clamp on amp meter, megger and ohm meter.
You could use a very sensitive Ohm Meter or you could get a longer piece, such as 100 m, measure with an Ohm Meter and divide by 100. The problem is that the resistance of 1 meter length will be very low and it would be hard to get a reading other than zero from most Ohm Meters.
1 Ohm meter X (Mega Ohm/ 1000 Ohms) X (100 cm/meter) = 100/1000 Mega Ohm cm = 0.1 Mega Ohm cm method: dimensional analysis
Capacitance is measured in Farads. "The unit... in ohm and meter" does not make sense.
if it is ohm meter and not ohm per metre; divide by 1,000,000 to convert ohm to megaohm, then divide by 1000 further to convert metre into kilometre
Ohm meter
You can check glow plugs with an ohm meter. should be <1ohm