answersLogoWhite

0

Many manufactures make a 2.2 engine. What make are you asking about?

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Does a rotary engine consume more fuel than a conventional piston engine?

For it's size no but when compared to a piston engine with the same power, yes. Almost all Mazda rotary engines will get around 22 on the highway but only around 15-16 in the city. Not great for a small car like the RX but it is not a gas guzzler.


What is the location of the serial number on a folbert 22 rifle?

It may not have one. Check the barrel and breech area.


Where is the serial number on a Jennings J-22 location?

right-side, below slide, rear of grip


Stevens 22 cal single shot rifle serial number location?

Serial numbers were not required prior to 1968.


Why does a 22 hp Briggs stratton engine smoke when started?

We need more info on your particular engine. It could be anything ranging from adding too much oil, worn piston rings, or the fact that when the engine is started, the carburetor is being choked (cutting off much of the air supply) causing the engine to obtain air from elsewhere in the engine such as the crankcase or through leaking gaskets, etc..


What is the location of turn signal fuse for 2000 mountaineer?

the location is 22


What is the location on the periodic table?

22


When was Location View created?

Location View was created on 2006-06-22.


How much is a Strum Ruger 22 caliber long rifle automatic piston Mark 1 with a 5 12 inch barrel Serial number 199xxx is very very good condition worth?

150 USD


What is titaniums location on the periodic table?

22


How do you find top dead center on a Chevy 305?

For the purpose of installing a distributor, remove the coil wire, remove the number one spark plug (drivers side, first one up front), put your finger tightly into the number one spark plug hole, have some one jog the engine over with the key a little at a time until you feel compression coming from the number one spark plug hole, stop at that point and turn the engine by hand clockwise until the mark on the damper lines up with "0" on the timing scale. This will give you TDC for the number one cylinder on the power stroke. This is where you would drop the distributor in with the rotor lined up on the number one position on the distributor cap. For cam timing,A degree wheel and either a piston tdc spark plug stop or piston stop with head off. remove spark plugs. With degree wheel mounted on the crank,manually turn the engine over until piston 1 is close to TDC, distributor cap/rotor will get u close. put the degree wheel/pointer to 0. Install stop Turn the motorover by hand until the piston touches the stop, mark the degrees. Crank the engine in the (opposite direction 1+ complete turns)until it touches the stop. Marker the degrees down, add the 2 number(degrees before 0 and after 0) divide by 2 and that is the degrees# before/after 0 the piston should touch the stop. An example: if the piston touched 24 degress before 0, and again 20 degrees after 0. You need to adjust the wheel so it 2 degrees, so that the stop touches at 22 degrees before/after 0.


Is 22 an odd number?

No it's not. 22 is an even number.