The 8085 and 8086/8088 operate on 5 volts.
A lamp will only operate at its rated power if it is subjected to its rated voltage. Increase that voltage will increase the power of the lamp -in other words, it will operate more brightly. This is how 'photoflood' lamps operate -they are deliberately designed to operate at overvoltage. Of course, this reduces the life of the lamp.
8086 is a 16- bit microprocessor. It has 20-bit address bus. It has 14 16-bit registers. It has multiplexed address and data bus. It provides 33% duty cycle. 8086 supports multiprogramming. It is designed to operate in two modes, i.e. min and max. you can download the simulation program(for running your programs on your computer) at - http://www.ziddu.com/download/15018415/emu_8086.zip.html
The rated voltage of a motor listed on the nameplate is called the terminal voltage. This indicates the actual voltage on the motors terminals at which at which the manufacturer designed to operate. Whereas, Nominal voltage is the design or configuration voltage of the electricity distribution system.
A DC motor can be built to operate on any voltage.
The voltage for a potential relay will depend on the circuit that the relay is installed in. The relay can be made for low voltages (5v) to higher voltages (440.)
The supply voltage of the 8085 is 5 volts.
a number (1) because 8085+1=8086
No. The 8086 has instructions not present in the 8085. The 8086 was marketed as "source compatible" with the 8085, meaning that there was a translator program which could convert assembly language code for the 8085 into assembly language code for the 8086. However, this does not mean that the compiled 8086 assembly code would then run on an 8085; among other things, the 8086 was a true 16-bit processor, as opposed to the 8085 which was an 8-bit processor that supported a few 16-bit operations.
The 8085 was replaced with the 8086/8088. As such, there is no 16 bit version of the 8085.
No. RST7.5 is a maskable interrupt on the 8085, not the 8086/8088.
The most significant difference between the Intel 8085 and 8086 microprocessors is that the 8085 is an 8-bit system and the 8086 is a 16-bit system. This difference allows the 8086 system to have a much larger set of operational instructions and can make calculations to more significant places. Note: the 8085 processor does have two 16-bit registers. The pointer and the program counter.
128Kb
indexed addressing
The address bus in the 8085 is 16 bits wide.
Pin 28 on the 8086/8088 is M/IO-, in minimum mode. The equivalent pin on the 8085 is IO/M-, and has opposite polarity.
The Intel 8085 is an 8 bit microprocessor created in 1977.The Intel 8086 is a 16 bit microprocessor created in 1978. The 8086 was the first chip to start the x86 architecture family.8085 contains 16-bit address bus and 8-bit data bus8086 contains 20-bit address bus and 16-bit data bus..In 8085 the clock speed is 3MHZwhere as in 8086 the clock speed is 5MHZ.there are two differences btw 8085&80861. 8086 has 6 byte queue but 8085 has 4 byte queue2. 8086 has 16 bit data bus where as 8085 has 8 bit data bus
bcoz its operate on 5v only.it is a 8 bit micro processor.800 is series 5 is the voltage