0
Out of 8 cables in a wire which is esssentially need to be correctly crimped?
Wiki User
∙ 15y ago
FOR CAT 5 OR CAT 6 LAN CABLES -- ALL SHOULD BE CORRECTLY CRIMPED AND ITS COLOR CODING ARRANGEMENT TO SERVE ITS PURPOSE.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the minimum size neutral for three sets of parallel 500kcm copper conductors for a service?
On large service entrance services the neutral can be reduced. The amperage of the service and the voltage of the service and the insulation factor of the 500 MCM conductors need to be stated to answer this question correctly.
What are the disadvantages of bus duct?
Bus ducts no doubt compact, need routine checks for loose connections at joints. Any loose connections is not easily visible (to infrared scan) since they are enclosed. A poor quality out door bus bar, water can enter. These factors can make the busbar vulnerable. Where as cables, are more easily maintainable and are low on investment. G.RAO
Why are low voltage electrical cables earthed and high voltage cables not in an electrical system?
The answer is more obvious if you use slightly different terminology to ask it. You could re-phrase the question as:Why are the low-voltage wires in a building earthed , but high-voltage transmission lines not?Wiring in a building or home that a person may come in contact with is earthed, or grounded for safety. If a live conductor in a grounded system comes in contact with an equipment frame or other metal object, fault current flows and trips the overcurrent device. If the building's wiring were not ground-referenced, you could have exposed live parts and not know it. Surprise!On the other hand, high-voltage transmission lines are optimized to transport electrical power long distances. Power transmission typically uses 3-phase delta which does not need an earth connection. The grounded conductor, or neutral, is derived locally after the distribution transformer. Overcurrent protection is for the protection of the lines themselves, not for people that might accidentally come in contact with them! This is why there are such strict rules concerning keeping us separated from the transmission lines.Keep in mind that the transmission towers themselves are grounded, and there is usually a grounded wire up top, but this does not form part of the transmission system, it is there for lightning protection.AnswerUnderground high-voltage cables are earthed.
What are the effect of electrical cable joint?
A cable joint is the term used in the UK for what, in North America, is called a cable splice.In the case of high- and medium-voltage underground cables, if they are done correctly, there is no adverse affect and joints should last as long as the cable itself. A great deal of care is taken replacing the insulation after jointing the conductors themselves, and to ensure that the cable remains waterproof and any armouring is replaced. HV and MV cable jointers are highly-skilled tradesmen who have completed an apprenticeship in cable jointing.More_Information:">More Information:The connection of wires is typically called a splice (North American term). If the splice involves two different types of wire like copper and aluminum you would have to use special connectors made for this purpose and perhaps a compound made for the purpose. In the normal connection of two or more wires of the same type you need to make sure the ends of the wires are clean and that the connection is firm so as to reduce resistance at the joint. You also need to make the splice in a junction box for power wiring applications; and that bare wire isn't exposed which could cause shock or shorting situations. Underground splices pose yet another problem with moisture and varmints chewing on the splice.
Are you able to set up a 24 volt system in your 12 volt land rover to run a 24volt winch?
Yes, you will need to install a second 12V battery in series with your existing 12V battery to supply 24V to the winch. However, to keep them charged, they have to be charged in parallel. You'll need a schematic to do this correctly and not damage the winch or batteries. I recommend you contact the winch manufacturer for a schematic. It might be best to purchase two new 12V batteries to operate the winch and not tie into your Land Rovers battery. I would purchase "deep cycle" marine batteries such as are used in boats and RVs. These will give you the best performance They are available anywhere batteries are sold.
No, You need to add cables in the lengths you need.?
No, You need to add cables in the lengths you need.
What cables do I need to connect a camcorder to my TV?
Simple video cables will be all you need.
Ethernet Cable?
form_title=Ethernet Cable form_header=Connect to the internet with an ethernet cable. How many ethernet cables would you need?= {(),1,2,3,4,5,6,7,8,9,10} How long do the cables need to be?=_ Where do you need the ethernet cables?=_
Why do jumper cables melt when trying to jump start a car even when they are hooked up correctly?
There its too much current running through them. If they are hooked up properly then you either have a short some where (positive wire that is touching ground) or the jumper cables can't handle the current demanded by the vehicle you are trying to start. If this is the problem, you need jumper cables that are a thicker gage wire.
Cables?
form_title=Cables form_header=Connect to your technology with cables! How many items will require cables?= {(),1,2,3,4,5,6,7,8,9,10,More than 10} Are there certain cables you are looking for?= () Yes () No If so, what kind?=_ Will you need adapters with your cables?= () Yes () No () Not Sure
What do you need to connect two hard drive and one CD burner?
You need two cables called IDE cables. Typically these cables have the ability to connect two hard drives or two CD DVD roms. So just find two IDE cables and you can conect what you need to connect.
What type of cables do I need to connect my DVR.?
SCSI or HDMI cables are used for connecting your DVR.
Do I need HDMI Cables for my HDTV, or can I use the component cables that came with my HD cable box?
You don't need HDMI cables for an HD signal, but if you want to get maximum resolution for your tv (1080 p) you do. The short answer is no, you do not need HDMI Cables just to get an HD signal. BUT HDMI cables transfer the higher-resolution images at a faster rate, giving you a much better picture.
What does the site Cables To Go sell?
Cables To Go sell a number of household electrical equipment for a cheap price. They primarily sell cables for wiring like computer cables and other forms of cables you need to connect to your computer.
Do I need cables to connect my computer to TV?
Yes, you do need cables to connect your computer to your television. You can also use the guide to find out about what type of cable that you need to connect the computer to the television.
What cables do you need to convert Sony hadycam ccdtrv128 hi8 to tapes?
The cables that you need to convert Sony handycam CCDTRV128 Hi8 tapes are AV cables. This will allow you to transfer the data into a PC and save them in digital format.?æ
Can 12- 3 wire be used for 20' jumper cables?
No, you need at least 8 gauge for jumper cables.
