Want this question answered?
Combined overhead variance = fixed overhead variance + variable overhead varianceFixed Overhead :which remains fixed and donot change upto certain level of productionVariable Overhead: which keep changing with the change in production units.
Using direct labor hours: Overhead rate = Total Overhead Expenses /Direct labor hours Using Machine hours: Overhead rate = Total Overhead Expenses /Machine hours
Blanket overhead rate is the computation of a single overhead rate for one whole factory. Overhead rate is the percentage you get when comparing total overhead expenses to total expenses.
APPLIED Overhead is computed using the predetermined overhead rate and is the amount of costs applied (or estimated) to be allocated (needed) for specific jobs. ACTUAL Overhead is found after the manufacturing process is complete which gives the actual amount of used/consumed resources (or total costs) that it needed to complete the job. The two amounts can then be compared afterward which is known as Under- or Overapplied Manufacturing Overhead. When Manufacturing Overhead has a DEBIT balance, overhead is said to be UNDERAPPLIED, meaning that the overhead applied to work in process or to the certain job is LESS than the overhead incurred. On the contrary, when manufacturing overhead has a CREDIT balance, overhead is OVERAPPLIED, meaning that the overhead assigned to work in process or to the certain job is GREATER than the overhead incurred.
what isfactory overhead applied
they are made of alluminium
beacuse is good
heat causes the particles to expand in tire so its loose and slack, where as in winter its taught due to lack kinetic energy breaking bonds. Same with overhead power cables.
there arent any cables just a rod. If there is too much slack replace the handle.
Overhead transmission lines are less expensive, in most cases, significantly less expensive, than underground cables. Underground transmission cables require insulation, cooling systems, and -the most expensive feature- excavation!
In computer networking, "pulling cables" refers to running cables from one point to another (generally through a wall or crawl space, where you feed one end through, then go to the other side and pull them the rest of the way), so "Do not pull those cables" means to not run the specified cables. Often times, pulled cables are left with slack in them so that if components (computers, routers, etc.) need to be moved, you can simply pull ON the cable to gather slack. If, however, the cables have been pulled without slack, then those wires should not be pulled on
A bridge with overhead cables to support it.
Number of reasons: * Provides room for expansion when the building heats up. * Allows slack to move wires when remodeling. * Allows slack to reconnect wires when redoing terminations.
Number of reasons: * Provides room for expansion when the building heats up. * Allows slack to move wires when remodeling. * Allows slack to reconnect wires when redoing terminations.
power cables under ground rather then overhead.
First of all, the overhead lines are cheaper because they are bare, while underground cables are armoured and insulated, hence explaining the higher price. Overhead cables come of course with accessories like poles and insulators (mostly porcelain). For shorter distance, underground cables are preferred as the cost of pole erection does not exist.It's also worth pointing out that the cost of excavating a trench is more expensive than erecting an overhead line, and this cost escalates dramatically with higher voltage systems. For example, a 132-kV double-circuit underground line is between 5 and 8 times the cost of an overhead tower line, whereas an 11-kV single-circuit underground line is up to twice the cost of a wooden-pole overhead line.
Tides affect fishing because they can provide plenty of fish for fishermen. For example, when the tide is moving, it is more productive and doesn't have slack. When there is less of a slack, then there will be more fishes in the surf.