0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is the Chrysler PT Cruiser engine light on followed by one chime?
The engine light on followed by one chime in a PT Cruiser is a notice to the driver that something is wrong in the engine. The chime sounds only to make sure the driver notices the engine light.
Why is the check engine light on a 2006 PT Cruiser?
The check engine light comes on when the engine computer detects a malfunction and sets a trouble code.
What is the symbol for a 2004 PT Cruiser check engine light?
It is a little yellow engine.
How can you fix it 90 Toyota land cruiser engine light 25.26?
The best way to fix the engine light in your Land Cruiser is to fix the problem. There are many reasons your check engine light could be on including a loose gas cap and problems with your engine.
Why does the interior light come on and the warning chime sounds on a PT cruiser when going round a corner to the right?
Check to make sure that the doors are shut completely.
Check engine light flashes on PT Cruiser while accelerating.?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
How do you reset the check engine light on a 2007 Chrysler PT Cruiser?
You use a scan tool after repairing the cause of the code.
Will the throttle position sensor on a pt cruiser cause car to stall with no check engine light on?
It is possible.It is possible.
How to reset check engine light 1991 Toyota land cruiser?
try disconecting the battery or pulling the ECM fuse
How do you reset the check engine light on a 2006 Chrysler PT Cruiser?
You use a scan tool after repairing the failure that caused the code.
How do you reset the check engine light on a 2003 Chrysler PT Cruiser?
You can unhook the battery or use a scan tool to erase the code. If the cause is not repaired, the light will return.
I get a voltage of 8.3v at the dome light but 12.3 at the fuse block and the dome light won't come on and neither will the warning chime bell?
remove warning chime bell and doom light use meter to check voltage at chime supply in from fuse to chime bell and the dome light see if dc voltage go to 12.3 or 13volts you got a bad capcitor on chime bell or small ground on b+ after fuse or some thing pull 12vdc down step 1 check to if you get 12.8vdc on dome light first ,,after check for 12.8 at chime bell too ok /? check wires see if there good not fry but pop the fuse
