Fracture point
To convert breaking strain to safe working load you must establish a safety factor (SF). Assume SF of 10. If a line has a breaking strain of 1 tonne then you should only suspend or load the line to a strain of 100Kg (1000Kg/10) A common SF for normal use is 6. If human loads are in use then SF 10 is more common.
initially there is the linear elastic region which obeys the hooks law :stress is directly proportional to the strain. at the end of the linear elastic region the ductile material reaches the yield point beyond which any change in dimensions become permanent. the material goes through a yield plateau in which stress is constant and the strain changes. after crossing the yield plateau the ductile material goes through the strain hardening region in which the deformation is permanent but as the region goes on the stress increases with the strain. here the strength of the ductile material increases as it is strain hardened. at a point it reaches the ultimate load point. This is the maximum load taken by the material. after which further deformation causes decrease in strength or the stress goes on decreasing finally breaking at the breaking load point. this region is called the post-ultimate region.
A material will be graded as brittle when it breaks with only a small amount of strain. Its brittleness is based on the amount of deformation used to break the material.
strain-to-failure
The strain gage indicates strain, and the stress is from Hooke's law; stress = modulus times strain so you need to know the modulus of elasticity
Within Elastic limit, the strain produced in a body is directly proportional to the stress applied to that body.
Breaking strain relates to the force required to snap fishing line under tension. Differing strengths of fishing line are categorized by their pre-tested "breaking strains".
300kg
a strain to ones body or mind
The definition of microbial strain improvement is the development of improved strains that are used in the fermentation process. This is commonly used in the production of industrial products.
That would be 4.53592 Kg.
Strain is the change in dimensions per unit original dimensions. For example, if your stretch a 100 cm long wire by 5 cm, Strain = 5/100 = 0.05
To convert breaking strain to safe working load you must establish a safety factor (SF). Assume SF of 10. If a line has a breaking strain of 1 tonne then you should only suspend or load the line to a strain of 100Kg (1000Kg/10) A common SF for normal use is 6. If human loads are in use then SF 10 is more common.
hook'law state that when a force is applied to the body then the stress produced in the body is directly propotional to the strain within the elastic limit stress = e & strain
Use the formula Strain=Extension/original length and rearrange to give Original length=Extension/Strain. Substitute the values you have for the strain and the extended length into the equation and voila! Source: Doing A-level (senior high-school in America) Maths and Physics.
Back pain is a kind of pain which may include muscle strain or pressure on the root of a nerve.
The stress,strain in muscles of a human body is called soft tissue injuries