Blower switch and connection had a melt down.
did you find a solution yet
The orfice can be found either in the ac condinser or at a coupling sometimes at the radator but it is the ac line on the high side I do believe.
the inside bulbs are the high beams.
Trouble code P0118 means: Engine Coolant Temperature Circuit High Input Replace the Coolant Temp Sensor
buy the book on your car car.
It will depend on year of Pontiac Grand Am and whether you are looking for high-beam or low beam. See sources and related links below to lookup by make, model and year.
Idle speed too high.
blower motor resister is bad
It is located to the rear of the fuel tank and behind the rear differential up high.
Trouble code P0108 means:MAP Sensor Circuit High Input
the low beam part of the bulb could be bad.
Yes it will fit rather nicely. Be careful, though, that you first incorporate the high impact jizm load indicator before tightening the rotational chaumfaxing resuscitator. If you remember to do it, changing doors will be a breeze.
It depends on the engine. On my 94 Grand am with 3.1 V6 I get about 19 miles to the gallon in town and 25 miles to the gallon on the high way. David
There is a resistor pack operated by the fan switch. It has failed. You need to replace it.
Pontiac Central High School was created in 1849.
Pontiac Central High School ended in 2009.
Pontiac Township High School was created in 1898.
Perhaps throttle plate is stuck open. try to "free " with a screwdriver or perhaps a vacuum leak
If you have a Carquest auto supplier nearby, part #209283 (Blower motor w/wheel) and check the resister (if you only have high speed) also. Approx $200.00
It might be the high/low beam switch. Had to replace one on my '96 when I had only low beams.
Its on the stearing colume up real high some dash assembly might need removed