it could be that you are getting low on toner pull out the cartridge shake it side to side then installed it back if the copy improve then you need a toner cartridge.it it dont improve then.. clean the transfer corona wire located at bottom of machine were the paper goes over .you may need a flash to see the wire.its about 3 times thicker than a humans hair be careful not to break.the wire run side to side and most of the time is in a chome looking metal holder.good luck.
If you want to print only the fourth page of your research document, you can easily do that. Just go to the printer options and select the current page you want to print and you will have it printed.
i suggest just cut the paper
It should only print one page per sheet. Check all the print settings and ensure the printer and the application you are using are set to print on the size of paper you are using.
page setup is customization of page and print preview is how it will look when you send page to printer
Have you installed a printer? Is the printer set as default?
If the printer has been added as a local printer, and can successfully print data (test page, text documents, etc) sent to it, then it can also print a picture.
Whenever you print a page a copy of the page is stored directly in the RAM within the printer. The printer RAM is just to serve as a temporary storage facility until the paper is printed out, just in case there is an error with the printer or the page and it has to be reprinted. It would allow the printer to reprint the page without having to find the page and hit print again.
You can print any WikiAnswers page by clicking the "Printer" icon in the top-right hand corner of any page.
Have you "add a new printer" properly? Not enough info to be more specific! It is probably that the driver needed to run the printer properly has not been installed!
The print margins on the printer setup are probably off. Look at your printer setup.
that laser printer and error occurs if the printer does not have enough memory hold the entire page for other a part of the page and send an error messges for low memory overflow or out of memory so the solution is to install more memory or to print only simple gages with few graphics
You have to choose options Fit to page and Print all pages.