0
Best Answer
Overhead cam engines don't use push-rods.
Wiki User
∙ 16y agoThis answer is:
Add your answer:
Earn +20 ptsQ: Push rod locations for a 1997 Oldsmobile acheiva 3.1?
Write your answer...
Submit
Still have questions?
Related questions
When you push the gas to go there is a popping noise from the rear of the car when you push the gas to go its also there along with a grinding nose you have a 1996 Oldsmobile acheiva?
A) water in the gas tank B) fried piston rings C) long term engine neglect
How can I Replace rear brakes on 1997 Oldsmobile Cutlass Supreme?
you have to turn the pistons at the same time you push the pistons in
How do you fix the 1997 Oldsmobile cutlass fuel gauge which is turned upside down and stuck below E?
Stick a peace of wire threw the hole of the mileage reset button and push it over.
How do you open the radiator cap on a 1999 Oldsmobile Intrigue?
Push down and turn counterclockwise
When was Push It - Garbage song - created?
Push It - Garbage song - was created in 1997-03.
How do you replace the flasher on a 2003 alero Oldsmobile?
Just pull the old one out and push the new one in.
How do you reset information center on a 1995 Oldsmobile ninety eight?
Push reset when the problem code comes up.
Where and how do you turn the long headlights in an Oldsmobile cutlas supreme 1991?
switch is down on the left mines a push type
How do you reset the overhead fuel info on an Oldsmobile Bravada?
Push both buttons at the same time, it will reset to zero.
How do you close the sunroof on a 1997 mercury mountaineer?
Push the button
How do you push the caliper in on a 1990 Oldsmobile cutlass supreme?
Use a "C" Clamp to fully retract the piston into the caliper body
How do you place pushrods for 1994 Oldsmobile cutlass supreme?
Is this for a 3.1 or 3100 V6? If so, the short push rods are for the intake valves.
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.