0
What are the wirering codes for the back of the 1999 hyundia sonata.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you find a wiring schematic for a 2005 Hyundai sonata stock radio?
The actual compononts in the radio or for the power/speaker plug on back?
Where is the wiring hares for the radio in a 1991 gmc pickup?
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
The volume on your radio keeps going back to zero by itself on a 2009 Hyundai Sonata?
that's normal
How do you hardwire a car stereo to a 1999 Chrysler Cirrus?
Hardwire means "physical stuff not software". It means: take the loose wires of your radio - (No factory plug on the wires) and tie it to the wires of the car radio wiring. (There are wiring kits that may adapt your vehicle to the radio if both of the radios still has it's plug $&20) You have to match and splice, or tie together all of the desired or required wires from your new radio to the vehicle radio wiring... I suggest you do not cut out the vehicle radio plug but skin the wires back a little here and there (and tape up afterwards) to get a connction you need and solder the radio's leads to the vehicle wiring just behind the original's radio plug. LOL
How do you remove the radio from a 1993 Cadillac Deville?
Remove the decorative radio cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness from the back of the radio.
How do you remove radio from 1997 Dodge Ram?
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.
How do you install a new radio in a 1976 c10 Chevy?
Connect the wiring harness on the back of your new radio. Slide the radio into the radio slot. Tighten down the radio retaining screws.
How do you install radio in 1969 Chevrolet Impala?
Connect the wiring harness and the antenna cable to the back of the new radio. Slide the radio into the radio slot. Secure the radio with the retaining screws.
How do you remove the 2002 Chevy Avalanche factory radio and install a after market one?
FIRST REMOVE THE TRIM PIECE THAT RUNS AROUND THE WHOLE DASH. IT POPS OUT, BUT BE GENTLE ENOUGH NOT TO BREAK IT BECAUSE IT IS PLASTIC. THEN ON THE LEFT AND RIGHT SIDE OF DELCO RADIOS THERE ARE TABS THAT YOU PUSH DOWN AND IT RELEASES THE RADIO. PULL THE RADIO STRAIGHT OUT. YOU WILL HAVE TO REMOVE THE ANTENNA PLUG FROM THE BACK OF THE RADIO AND THE WIRING HARNESSES FROM THE BACK OF THE RADIO. FOR A NORMAL DIN RADIO REPLACEMENT YOU WILL HAVE TO PURCHASE AN ADAPTOR KIT FOR THE OPENING. YOU CAN PURCHASE THESE AT ANY STEREO SHOP OR WAL-MART, OR RADIO SHACK. YOU WILL ALSO NEED TO PURCHASE THE ADAPTOR WIRING HARNESS TO FIT YOUR VEHICLE SO YOU DONT HAVE TO SPLICE ALL OF THE WIRING TOGETHER. MATCH THE WIRING FROM YOUR REPLACEMENT RADIO TO THE WIRING HARNESS AND MOUNT THE RADIO IN THE ADAPTOR KIT. INSTALL THE RADIO INTO THE OPENING AND PLUG ALL OF THE WIRING BACK TO THE FACTORY PLUGS. REPLACE THE TRIM RING BACK ONTO THE DASH AND YOUR DONE. ABOUT AN HOUR TO DO EVERYTHING IF YOU HAVE EVERYTHING READY TO GO. HOPE THIS HELPS!!!
How do you disconnect the radio antenna on a 1999 Oldsmobile intrigue?
Disconnect from the radio by unplugging it from the back of the receiver. It has a standard radio plug.
Where can you get a radio wiring diagram for a 1985 Jeep Wagoneer?
there is one in the back of the haynes repair manual.
How do you remove the radio on a 2000 Eldorado?
Remove the decorative cover from your Cadillac Eldorado radio. Remove the radio retaining screws. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
