If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.
check brake fluid
Brake light on 1994 Honda civic staying on.
The Dodge Shadow stopped production in 1994
replace the headlight switch its wore out replace the headlight switch its wore out
if the tail lights work but not brake lights then its most likely just a blown fuse or it could be the switch at the top of your brake pedal arm.
Defective or mis-adjusted brake light switch
There is no brake light relay. There is however a brake light switch located above the brake pedal.
Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.
In my 1989 Dodge Dakota the brake light is on fuse number13 it is a 5amp it also goes to buzzer, speed control, check engine light, anti-lock warning light, and other things page 12-19 Haynes 1987- 1993 Dodge Dakota Repair Manual
It should say TAIL for taillights or maybe brake lights.
Change the turn signal flasher relay.
Brake Lights Stay on Unless the Brake Pedal is RaisedThis is usually caused by the brake light switch being out of adjustment in its physical distance to the contact point on the brake pedal arm.
where can you find a website for free diagram of tail light wiring on a 1994 dodge 1500 truck?
DOT 3 or DOT 4
a blown bulb or loose wire.
1994 gmc no brake lights 3 brake light works need help
it is broken Check the fuse, check the bulbs, check the brake light switch, in that order.
Check the bulbs, check the fuse, check the brake light switch, in that order.
There is a short to ground in the stop lamp circuit. The most common places for the short to be located are at either lamp, and at the trailer wiring(if equipped).
There is a switch just above the brake pedal that is called the brake stoplight switch. When the brake pedal is released, it stops the brake lights from illuminating. Check to make sure the switch is contacting the brake pedal stop where it should. A short term method of not killing the battery would be to unplug the connector to the switch and get a new one. It won't have brake lights when disconnected so I don't recommend driving with it like that. replace the broken switch
Dot 3 Brake fluid
check the fuses.
The multifunction switch inside the steering column is bad.
Possible brake line leak