6 bolts (you will need a cheater bar to get them out), and the wiring harness going to the lights on the back and the three screws holding the fuel filler to the bed.
have 2 of your buddies help you lift it straight up, then back
It may be more difficult to remove the bed than to drop the tank.
There should be about 8 bolts under the bed and the wiring harness
Yes. The Ford Ranger bed has gone unchanged since 1993. Any bed since 93 will fit. www.FordRanger.net
IN THE FUEL TANK. YOU HAVE TO REMOVE OR SLIDE THE CARGO BED BACK TO GET IT OUT.
Remove the 3 screws holding gas filler flange on bed and use 3/4 impact wrench to remove mm bolts in bed ,then disconnect wiring at end of bed (tail gate ) and lift bed as best you can
Can you take a Ford Ranger 1994 bed and put it on a 1994 Mazda B2300? Truth be told, they are the same truck. My 1995 B2300 has "Made for Mazda by Ford" on a sticker inside the door of the driver's side. Also, the Chilton's manual for the Mazda B series trucks are the same as the one for the Ford Ranger.
REMOVE THE BED OF THE TRUCK. YOU CAN GET TO THE BOLTS TO REMOVE THE TANK. 6 BOLTS AND UNPLUG THE WIREING HARNES.
It`s a Ford.
Last year of production for the Ford Ranger with the flareside bed was 2004.
If you have a long bed ranger then the answer is no. The edge was a short bed step side.
42"
Yes. All beds are made the same since 1993. www.FordRanger.net