push pin in hole in plastic on bottom of head rest bar.
How do I get the front grill off my 1997 Chevy suburban? I've removed the six visible screws holding it in place, but it still won't come out..
It takes a T55 Torx bit on the front calipers.
On the backside in the middle of the seats there is two buttons you have to push and then pull up the headrest. //Sam
Press into the fabric of the seat, immediately in front of the base of the headrest. This will release the catch, and the headrest can be adjusted up or down, or removed entirely from the seat.
The amount of Freon that goes into a 1995 Chevy Suburban depends on whether or not their is just front AC or front and rear AC. If the Chevy Suburban on front AC only it takes 3.0 pounds of r134a Freon. If there is front and rear AC then it takes4.25 pounds of r134a Freon.
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
Yes they will, There the same thing.
The head rest can be removed by inserting a small pin in the hole on the clip that does not have a button. Push the pin in that hole and lift on the headrest. You can also remove the plastic cover and just push the button.
under the front passengers seat
Where is front expansion valve for chevy suburban 1997
On most cars theres a lever that you push and it can adjust hieght.But older cars no. 2012 Cruze has two types of headrest, the rear have a button release on BOTH posts in order to fully remove the headrest. The front headrest does not have a second button as it is not intended to be removed. HOWEVER ..... if you look closely at the side that does not have a button, there is a very small hole. Use a small allen wrench, slide it into the hole to release the locking mechanism. You must also hold in the button on the other side and pull up on the headrest all at the same time. The headrest will slide right out. Do not drive the vehicle with the headrest removed. I only needed to remove the headrest to install a seat cover.