The front bearings are pressed into the hub. Take the axles out of the hub and remove the steering knuckle/hub assembly. Take them to a machine shop and have the bearings pressed out and back in again.
The rear bearings you just take off the grease cap. Unstake the keeper washer and take the nut off. Then you can pull the outer bearings out. then replace the nut on the spindle and pull out again which will take the inner bearing out along with the seal.
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.
How to remove rear wheel bearings on a 1978 corvette..?
Remove the tire and wheel from your 2003 Kia. Remove the axle end. Remove the wheel bearing retaining nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearings.
pop them out of the wheel
Jack it up, remove the wheel, pry off the center cap, remove the cotter pin and nut, then pull the bearings out with the hub. Note that some trailer bearings are sealed and replaced as an entire unit.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
they are replaced as hub assemblies, remove the wheel, remove the caliper and rotor three bolts for the hub, axle nut, abs harness if the car has it, and remove the hub assy
Front or rear?
You must remove the wheel bearings, inspect them, repack them with grease, and install them back in the vehicle.
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.