disconnect negative cable from battery ,raise vehicle in air place securley on jackstands,disconnect the leads from the starter,there should be one clip connection and oneterminal held on by a nut and washer,remove the bolts retaining the starter to the bellhousing remove the starter,sometimes it may be required to loosen the exhaust to have enough clearance to remove the starter ,but not always,toreplace starter just reverse the removal procedures.
inside starter.
It is a very involved project and too difficult to explain. Go buy a repair manual and it will give you step-by-step instructions. the starter will run you about 65 dollars
on the right side of the pickup get on the ground in look up the starter is about 6 inches long make sure toremove both battier cables before removing the starting.. two 14mm one top one bottom
depends on what motor is in both of them are they both 4cyle or 6cyle
How hard is it to change the rear main seal in my 1992 toyota pickup , with the 3.0 V6
It can cost up to about 2000 dollars to replace the clutch in the 1992 Toyota pickup. This varies with the type of parts required and with where you are located.
about 3 hours
You will probably get a ticket for a very loud vehicle. No real benefit can be obtained by removing the muffler on a small 4 cylinder or V6.
inside the tranny
What octane of gas should I run in my 1992 Toyota pick up 22re
replaceing windshield wipers toyota truck
were is the relay for 4x4 fuel pump 1992