P0108 - Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Yes, the MAP sensor may be bad, but check the electrical connection first, if a new one does not fix the issue, and you have ruled out all wiring issues the ECM may be to blame.
p0108 is map sensor signal high. Replace map sensor
Check all your wiring for your map sensor, if ok replace the map sensor.
Trouble code P0108 means: MAP Sensor Circuit High Input
Trouble code P0108 means: MAP Sensor Circuit High Input
Map sensor fault
Map sensor circuit voltage highMap sensor circuit voltage high
P0108 is map sensor volts too high. The map sensor could be bad, or the wiring could be broken. The map sensor bolts to the rear of the intake on the 4cyl.
You can try cleaning the map sensor and checking turbo speed sensor.
Replace sensor and clear code.
P0202 is injector number 2 circuit open. P2074 is map sensor TPS correlation. P0108 is map sensor circuit high. With all three codes I would think the wiring harness has been pinched or damaged near the rear valve cover, driver side.
PO108 Manifold Absolute Pressure Circuit High Input.Can be defective MAP sensor Vacuum leak Short in wiring Loose ground wire
low pressure on you MAP sensor clean it or replace it