Want this question answered?
Throttle plate stuck in open position
Unplug the wire on the side,remove the screw on it,,pull it off and replace with new one.
The Throttle Position Sensor (TPS Sensor) is located underneath the air intake< right below the Idle Control Valve. If your new, Find where your throttle cable hooks up & its right there. Its on the throttle body. When you follow the throttle cable, you will see it go to a lever that turns a shaft. The TPS is on the opposite end of the shaft.
You can unlock your Oldsmobile Cutlass antitheft stereo by removing the stereo fuse. Keep the fuse out for 30 seconds and replace it to its original position.
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
you can't you have to replace it!
can i reset it or replace it ,where is it on the car
Oldsmobile Cutlass was created in 1961.
Yes, you do.
how do you replace the headlight switch on a 1993 cutlas ceria*
You didn't mention what engine...etc. But for the most part you want .05 to 1.0 volt at idle and 4.5 to 5.0 volts at wide open throttle. It should also increase smoothly as you slowly open the throttle. If it skips and jumps around the TPS is bad.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine