Check the electrical ignition switch on the bottom of the steering column.
i have the exact same problem i changed the water pump last night waited an hour to make sure gasket dries placed water in it and it wont start. i replaced everything as i took it apart and i dont understand it.
i dont think it can run once it is out of diesel
it shouldnt, the fuel mix is prolly 32:1 and if it dont start check the spark and after that check ur air filter finally if it still dont start then its ur carb and i dont understand what u mean about the cutch
i cant get my car out of parkwhen its cold replaced the brake switch still dont work
Had same problem on my 03. Replaced the fuel and air filter and had plugs replaced. Ran like new after. Dont know which its was but a place to start.
when you change the fues and relay switches and the truck dont start what to do next.
I am going to ckeck my my brake line and see what is going on. I will tell you the problems I run into. Usually I like to take it to somebody but my truck is such a red neck truck that I dont like taking it to somebody because they always try to rebuilt the dam truck. If you understand what your truck is driving then you know what needs to be replaced.
There are some aspects that I dont have information enough to answer but first you should check the connection at the starter motor, the big red cable from the battery should connect there and should be securely fastened and clean, no corrosion is acceptable.Next i guess would be the start relay, then maybe the ignition switch.
you dont its fake
old myth, bad for alternator, dont do this..
have you checked the batterys even if there not installed in the vehicle the can still drain down
i dont know you tell me