u will need appropriate wrench to remove driveshaft you will then need a seal puller to pull old seal. then you need a hammer to tap new seal into place. then same wrench to reinstall driveshaft
The Ford Crown Victoria has an automatic 4-speed overdrive transmission. In 1992, the transmission was redesigned to include electronic controls.
No, different electronics/sensors.
It should be a direct swap.
No, the 1983 - 1992 Crown Victorias used the AOD transmission and the 1993-1994 Crown Victorias used the AODE transmission, so they would be different. Sorry!
on the transmission where the engine and transmission join.
I believe that is a ( 4R70W ) automatic transmission
There is no direct replacement. The Ford Taurus is Ford big car now.
Yes, both model years are AOD transmissions.
Yes, but is there air suspension involved? If so, there are replacement springs for the air bags.
The steering gearbox for the Crown Victoria is connected to the vehicle's frame and is attached to the transmission. All gears for the transmission are contained within the transmission itself.
i heard its in the transmission itself,, in the ppan
It is important to replace old transmission fluid with the right amount of new transmission fluid. The 2005 Ford Crown Victoria has a transmission fluid capacity of 5 quarts.
it is on a transmission housing
the transmission drain plug is located on the transmission underneath the dash area
in the transmission dip stick tube with a funnel
Not really much you can do. Take it to a transmission shop for an evaluation.
on the tail shaft of the transmission