The bulb is burned out
Probably a bad bulb They are double filamented with the smaller filament for stop and turn Larger is for tail light
If you're certain the bulbs and sockets are good, check the light wiring under the vehicle. There are a couple plugs that may be corroded if moisture was able to get in. If that's not the problem, it could be the turn signal switch on the dashboard.
Yes, they do. If you have a green signal to turn left, the opposing lane will have a red light. Even though vehicles may turn right on red (unless otherwise indicated), they are still required to stop and yield right of way on a red light.
If you're in a country which drives on the right, you can make a right turn at a stop light (unless it's marked otherwise), and some jurisdictions will allow left hand turns. But you must wait until that light turns green before proceeding straight ahead.
whoever did not stop i guess. obviously there had to be a light or a stop sign and someone did not obey the stop sign or light. the first to stop at a 4 way stop has the right to go, if it is a light well someone blew the light.
It's really situation dependent. If the car which collided cross the intersection on a green light or a protected left turn (a green arrow), then they had the right-of-way. If that driver ran a stop light or sign, or failed to yield right-of-way when they didn't have a protected left turn, they'd be liable.
Check bulb and socket Should be a double filament bulb--smaller for Stop and Turn larger for tail light
The left and right stop light bulbs are reached by pulling off the cover panel to the left and right of the trunk opening. Twist the socket to gain access to the bulb . I believe the bulb pulls out of the socket. To replace the bulb in the high mounted stop light,push in on the back of the cover about an inch from each corner where the housing contacts the shelf. This will free two tabs and the whole assembly should pivot up where you can remove the socket and bulb.
To light the torches just stop right next to them and they will light up. That's why the sign says stop at the lights. :)
Left
The short cut is:Right,Left,Right,Left,Right,Left. You stop to look around at the dead end.
See the amswer for "How do you change the rear stop light bulb on a 2002 Jeep Liberty passenger side". It works.