answersLogoWhite

0

What else can I help you with?

Related Questions

What information about the router and its startup process can be gathered from the output of the show version command?

A


Which command or set of commands will stop the RIP routing process?

no router rip


Which command correctly starts routing process in cisco router?

To start the routing process on a Cisco router, you typically enter the command router [routing_protocol] in global configuration mode, where [routing_protocol] could be protocols like rip, ospf, or eigrp. For example, to start the OSPF routing process, you would use the command router ospf [process_id], where [process_id] is a unique identifier for the OSPF process. This command enables the routing protocol and allows for configuration of related settings.


What determines if the router implements a classless route lookup process?

The command ip classless is enabled on the router.


What command is to show router boot up process?

startup config


A network administrator enters the router osp 100 command. What is the function of the number 100 in this command?

process ID


What information is displayed in the output of the show version command on the router?

The show version command on a router displays detailed information about the device, including the software version, the router's model and serial number, uptime, memory and processor capacities, and the configuration register settings. It may also provide information about the interfaces, the last reload reason, and the system image file in use. This command is essential for understanding the router's current operational state and capabilities.


Do you need a router with new hp all in one computers?

no...go the the command prompt and type IPCONFIG and that will give you the information that you need to connect the router


Which command or set of commands will stop an RIP routing process?

To stop an RIP routing process on a Cisco router, you can use the command no router rip in global configuration mode. This command removes the RIP configuration and stops the RIP routing process from running. Alternatively, you can use shutdown within the RIP routing configuration mode to disable RIP without removing its configuration.


Which command allows a router to advertise default static routes via OSPF?

default-information originate


When configuring RIPng the command instructs the router to propagate a static default route?

default-information originate


What router prompt can you use the router rip command?

On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.