The oil will rise up to the top of the water and you can get some kind of material and soak out the oil with it.
Let it set. The two will separate by themselves. "Oil & water don't mix."
By floatatation
A mixture of oil and water is heterogeneous. Oil naturally separates from water and they can be separated by skimming the surface off the water.
the stuff in between the water and the oil after it separates is the still mixed oil and water. i did this for a science project and it stayed that way for 6 days!! the stuff in between the water and the oil after it separates is the still mixed oil and water. i did this for a science project and it stayed that way for 6 days!!
No, most oil is not soluble in water. Oil is hydrophobic, or "water fearing." This goes for all lipids. There are some water miscible oils but they are rare and typically only used in very specialty situations.
Sodium (Na) separates oxygen from water.
Yellow or white fluid mixed with oil is usually water. Check the level of your coolant. If the coolant is low, there is a possibility you have a cracked head or bad head gasket. A small amount of yellow/white fluid in your oil can be caused by condensation, a missing or loose oil fill cap, or even a bad oil pan gasket. Another possiblity is that oil which has not been changed over a very long period can absorb water. It could be water that has emulsified. Remove some of the oil and let it sit for a while. If water or anti-freeze separates to the bottom you are leaking coolant into the oil. The quad 4 has a history of head gasket and cylinder head problems.
water and oil
oil
A mixture of oil and water is heterogeneous. Oil naturally separates from water and they can be separated by skimming the surface off the water.
No it will not cause coalescence. Water separates from oil they do not mix or combine
Water is not a solvent for oils having a polar molecule.
anything more dense than the oil, like water.
Oil and Water
Canola oil is a type of oil extracted from rapeseed. Like all oils it separates from water due to it having non-polar irons where as water has polar irons.
the stuff in between the water and the oil after it separates is the still mixed oil and water. i did this for a science project and it stayed that way for 6 days!! the stuff in between the water and the oil after it separates is the still mixed oil and water. i did this for a science project and it stayed that way for 6 days!!
Put a few drops in a small cup, mix with water. If it mixes you have latex or acrylic. If it won't mix, or does so then separates it's oil based. -Experienced painters can tell by the odour.
Oil naturally separates from water and then may be skimmed off the top. For further purification, heating the oil allows the remaining water to evaporate.
An oil refinery